SUNRICHER ZigBee CCT Remote 95990474 Instruction Manual

ZigBee CCT Remote 95990474
Important: Read All Instructions Prior to Installation
Function introduction

Product Data

ZigBee Clusters Supported by This Remote Are As Follows:

Input clusters:

• Basic
• Power Configuration
• Identify
• Diagnostics

Output clusters:

• Identify
• Group
• Scene
• On/off
• Level control
• Ota
• Color control

Safety & Warnings

• This device contains AAA batteries that shall be stored and disposed of properly.
• DO NOT expose the device to moisture.

Operation

1. This ZigBee CCT remote is a wireless transmitter that communicates with a variety of ZigBee compatible systems. This transmitter sends wireless radio signals that are used to remotely control a compatible system.
2. This ZigBee remote supports 4 groups for binding max. 30 lighting devices and enables to control CCT ZigBee lighting devices.
3. Zigbee Network Pairing through Coordinator or Hub (Added to a Zigbee Network)
   Note:
   1) After pairing successfully, the remote information will appear on the controller or hub interface.

2. No remote information will appear on the hub interface if paired to Philips Hue Bridge.

4. TouchLink to a Zigbee Lighting Device
   Note:

1. Directly TouchLink (both not added to a ZigBee network), each remote can link with 30 devices.
2. TouchLink after both are added to a ZigBee network, each remote can link with max. 30 devices.
3. For Hue Bridge & Amazon Echo Plus, add remote and device to the network first then TouchLink.
4. After TouchLink, the remote can control the linked lighting devices.

5. Removed from a Zigbee Network through Coordinator or Hub Interface
   

6. Factory Reset Manually
   

7. Remove a Touchlink Paired ZigBee Lighting Device
   

8. Factory Reset a Lighting Device (Touch Reset)
   Note: the device shall be added to a network, the remote added to the same one or not added to any network.
   

9. Find and Bind a Zigbee Lighting Device
   Note: Make sure the device and remote are already added to the same Zigbee network.
   Note: Each remote can bind max. 30 lighting devices.

10. Find and Unbind a Zigbee Lighting Device
    

11. Clear All Find and Bind Mode Paired Lighting Devices of a Group
    

12. Setup a Network & Add Devices to the Network (No Coordinator or Hub Required)
    

13. Step 6: Add more remotes to the network as you would like.
    Step 7: Factory reset the lighting devices that you would like then add them to the network, refer to their manuals.
    Step 8: Touch link to pair the added remotes and lighting devices, refer to their manuals.
    Each remote can link with max. 30 lighting devices. Each lighting device can be linked by max. 30 remotes.

14. OTA
    The remote supports firmware updating through OTA and will acquire new firmware from Zigbee controller or hub every 10 minutes automatically.
    How to Check Whether the Remote Belongs to a Network or not
    Activate the remote by clicking All On/Off button (indicator on), then short press any other buttons except group buttons, indicator blinking 3 times means the remote does not belong to any network, blinking once or twice means it has already been added to a network.

15. Battery Power Monitor Function
    The remote will report battery power value to the coordinator under the following situations:
    • When powered on.
    • When short pressing both S2 and S3 buttons simultaneously.
    • When operating the switch to send data packets (over 4 hours since the last operation).
    • When added to the network by a coordinator.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>