EnvioLite 3F10NV57-48 3 Head LED Floodlight Installation Guide
- June 3, 2024
- EnvioLite
Table of Contents
EnvioLite 3F10NV57-48 3 Head LED Floodlight
OVERVIEW
- MODEL: 3F10NV57-48
- SKU #: 46335109032
INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions. Failure to do so may lead to electrical shock or fire, which may cause injury or death.
CAUTION
WARNING – RISK OF FIRE: Turn off the main power at the circuit breaker before installing the fixture, changing lamps, or performing other maintenance in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local, and national electrical codes. Prior to installation remove all protective plastic film covering from the fixture.
For questions, problems, or missing parts call the Customer Service line at 855-573-6156 from 8 AM to 6 PM EST, Monday- Friday.
Tools needed for installation
- Phillips screwdriver
- pliers.
Hardware Included
- 3 Wire Nuts
- 2 Machine Screws
- 1 Mounting Bracket
ASSEMBLY AND INSTALLATION
-
Turn the power off at the circuit breaker box or remove fuse. Note: This fixture is operating at 120Vac only.
-
Thread the screws (A) into the provided holes of the mounting bracket (B) and screw the mounting bracket into the outlet box (C).
-
Pull the power supply wires out from the outlet box (C). Connect the fixture ground wire and the supply ground wire together using a wire nut (D). Attach the white supply wire to the white fixture wire and the black supply wire to the black fixture wire using wire nuts (D). Add a cable tie below each wire nut to provide a more secure connection. Note: Fixture can be hooked to the bottom mounting bracket tabs before connecting the wires.
-
Carefully, tuck all the wires and wire connections into the outlet box (C).
-
Place the fixture pan (E) over the mounting bracket (B). Insert the mounting screws (F) at the top of the fixture pan (E) into the oblong slots (G) on the top of the mounting bracket (B).
-
Screw in the screws (H) into the front of the fixture pan (E) to secure the fixture.
Note: This is a blind operation, thread slowly to make sure the screws engage. -
Each head can be positioned in multiple directions via the adjustment screw (I, vertical position) and the lock nut (J, horizontal position). Note: Make sure to secure all locknuts and adjustment screws tightly after final adjustments to avoid water entry.
-
Apply silicone caulking (not included) around the perimeter of the fixture back where it contacts the mounting surface for moisture seal.