8BitDo M30 2.4G Wireless Gamepad/Controller Instruction Manual
- June 5, 2024
- 8Bitdo
Table of Contents
M30 2.4g — instruction manual
Genesis & Mega Drive (wireless connection)
- — plug the receiver into the controller port on the system. LEO on the receiver MI starts to blink
- — Press the mode button on the controller to pair with it Slue LEO becomes solid when the connection is successful
• 6 button mode s=> 3 button mode switching can be achieved by pressing the mode button on the controller for 3 seconds. LED on the receiver will blink twice to Indicate the change
• press and hold the mode button on the controller for 3 seconds to re- connect with a new receiver or to retrieve a lost connection. Blue LED becomes sold when the connection Is successful
Windows/Switch (wired connection) ****
- connect the controller to your Windows/Switch vie USB cable. Green LED becomes solid when the connection is successful
- The switch system needs to be 3. CTO or above. Then go to System Setting o Controller and Sensors and turn on Pro Controller Wired Communication
Turbo function
- — hold the button you would like to set turbo functionality to and then press the start button to activate/deactivate its turbo functionality
- — blue LED blot twice to indicate the success of activation/deactivation
• d-pad is not included
• this does not apply to Switch on a wired connection
battery
| stabs- | LED Indicator- | |
|---|---|---|
| low battery mode | | red LED blinks
battery charging| 
| red LED stays solid
battery fully charged| | LED turns off
- built-in 480 mAh U-on with 35 hours of playtime
- rechargeable via USB cable with 1 – 2 hours charging time
power saving
- Sleep mode -15 minutes without use
support
- please visit support.8bitdo.com for further Information & additional support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>