superbrightleds STN-3-UC Under Cabinet LED Flexible Light Strip Kit User Manual

June 5, 2024
superbrightleds

User Manual
STN-3-UC

Important: Read all instructions prior to installation.
Under Cabinet LED Flexible Light Strip Kit

Included Parts

1 – LED Strip
1 – Controller with Remote (MCBRF-RGBW)
1 – Power Supply (CPS-24V-60W)
1 – CPS Connector (CPS-F2ST)
1 – 10 ft Section of 5 Conductor 22 AWG Wire (RGBW-5Wire)
5 – Quick-Connect Terminal Block (LQC-2)
14 – Clamp-On Solderless Connectors (SBL-MA5P-12)
2 – Double-Sided Adhesive Foam Pads (3M-FTP)

Safety and Notes

  • The product should be installed in accordance with applicable national, state, and local electrical codes.
  • To reduce the risk of electric shock, ensure that the main power source is switched off and the power supply is disconnected before performing any installation or wiring procedures.
  •  The product is for use in dry, indoor locations only.
  • Do not connect the strip or controller directly to AC power.
  • Do not connect components other than those included to the power supply.
  • Ensure the polarity of all connections is correct during installation.

Installation Process

Preinstall Check
Remove strip from reel and make connections to power supply and controller. Briefly turn on the strip using the controller power button to ensure proper operation of the strip, power supply, controller, and remote. After a successful test, disconnect the power supply and disconnect components. Power Supply

Layout
Layout strip on the counter below cabinets. Hold strips up under cabinets or measure to determine the lengths of strip segments needed for installation. Cut the strip to desired lengths ensuring all cuts are made only on marked cut lines.
Strip Installation
Attach solderless connectors (SBL-MA5P-12) to strip ends by placing the connector fully over the strip and pushing down the cap until it locks in place.

Next, ensure all installation surfaces are clean and dry.
Begin to remove the strip’s backing while adhering to the bottom front edge of cabinets for optimal illumination. Press firmly to secure strips to the surface.

Route wire (RGBW-5Wire) for strip-to-strip connections under cabinet seams, windows, and other spaces between cabinets.
Cut the wire to length and attach wire ends to solderless connectors by placing the wire fully into the connector and pushing the cap down until it locks in place. Ensure the wires are connected to the correct polarity on the strip.

Controller and Power Connection
Use the double-sided foam adhesive pads (3M-FTP) to mount the controller. Connect lead wires at the end of the strip run to the controller (MCBRF-RGBW) with quick-connect terminal blocks (LQC-2). Connect the opposite end of the controller to the CPS Connector (CPS-F2ST).
Connect the power supply (CPS-24V-36W) to the CPS connector and apply power to check for proper operation.

General Installation Diagram

Note: Wiring may vary based on cabinet configuration and outlet availability.

Installation Components

¹UL certification only applies to the included strip and power supply

Rev Date: V3 04/22/2022
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533
superbrightleds.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

superbrightleds User Manuals

Related Manuals