8BitDo USB Wireless Adapter 2 Instruction Manual
- June 5, 2024
- 8Bitdo
Table of Contents
8BitDo USB Wireless Adapter 2
Instruction Manual
Controller Compatibility
- Xbox Series X|S, Xbox One Bluetooth controllers
- DualSense, DualShock 4, DualShock 3
- Wii Remote, Wii U Pro, Switch Joy-Con, Switch Pro
- 8BitDo Bluetooth controllers, and arcade sticks
Bluetooth controllers supported only. 2.4g controllers are not
supported.
One adapter can connect to one controller at a time.
Only one Joy-Con can be connected at a time, hold horizontally.
Classic controller and Nunchuk are supported to be connected to the Wii
Remote.
System Compatibility
-
Switch, Windows, Android, Raspberry Pi
-
PlayStation Classic, Genesis mini / Mega Drive mini, Retro Freak
-
USB-C OTG cable is required to connect to Switch Lite.
-
Android 4.0 or above, and OTG support are required on Android devices.
Ultimate Software
It gives you elite control over every piece of your controller: customize button mapping, adjust stick & trigger sensitivity, vibration control and create macros with any button combination.
- Please visit support.8bitdo.com for the application.
Support
Please visit support.8bitdo.com for further information & additional support.
FCC regulatory conformance
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference. (2) This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. Such
modifications could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
IC regulatory conformance
This device complies with CAN ICES-003 (B)/NMB-003(B).
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device. Cet
appareil est conforme à la norme CAN ICES-003 (B)/NMB-003 (B) .
RF Exposure
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>