Savant LEDX9DA21G22 Lighting Graphics Approval User Manual
- June 5, 2024
- SAVANT
Table of Contents
Savant LEDX9DA21G22 Lighting Graphics Approval
Getting Started
- Screw In the Bulb
- Turn On the Bulb
- Using Your Bluetooth
- Connect the bulb to play the music
NOTE: GE LED+ Speaker bulbs will sync automatically with other GE LED+
A21 or BR3O bulbs. Link this bulb with other bulbs to create a surround sound
experience. Bulbs can be controlled individually by using the remote within
close range of a specific bulb. Or, control all synced bulbs by using the
remote within close range of the parent build.
To link additional bulbs, turn on added bulb and it will automatically sync
with the parent bulb. Subsequent bulbs should he within 25ft the parent bulk.
Remote Control Included
This equipment complies with FCC &ICRF exposure limits for an uncontrolled
environment.This equipment should be installed and operated with a minimum
distance 20cm between the radiator &your body. The antennas used for this
product must not be co-located or operated in conjunction with av other
antenna or transmitter.
FCC requirements:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interterence, and (2) this device must accept any interterence received,
including interterence that may cause undesired operation. Any Changes or
moditications not expressly approved by the party responsible for compliance
could void the users authority to operate the equipment
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to trý to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontroled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator &i your body.
GE Lighting 1-888-MY-GE-LED
(1-888-694-3533)
www.gelighting.com
THE GE BRAND AND LOGO ARE TRADEMARKS OF THE GENERAL ELECTRIC company.
o2019 GE LIGHTING. INFORMATION PROVIDED IS SUBJECT TO CHANGE WITHOUT NOTICE.
ALL VALUES ARE DESIGN OR TYPICAL VALUES WHEN MEASURED UNDER LABORATORY
CONDITIONS,
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>