Savant PUU-CAMIDWDPHD1 Indoor Smart Camera User Manual
- June 5, 2024
- SAVANT
Table of Contents
Savant PUU-CAMIDWDPHD1 Indoor Smart Camera
SIMPLE DIY SET UP
INCLUDED
YOU NEED
MOUNTING WITH SCREENS
Mounting with Removable Adhesive Strips Identify Placement, Attach
Adhesive
Mount Camera to Wall
Incorrect Wall Plate Position
Incorrect Cable and Camera Position
Storing Content on the Camera
FCC Compliance Statement and Compliance Notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interfer- ence, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. Theselimits are
designed to provide reasonable protection against harmful interference in a
residenfial installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with thee
instructions, may cause harmful interference to radio communications.However,
there is no guarantee that interference will not occur in a particu- lar
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate fhe receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure statement
This equipment complies with FCC radiation exposurelimits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Canada Ic Compliance Statement
This device contains licence-exempt fransmitter (S)/receiver() that comply with Innovation, Science and Economic Development Canada’s licence-ex- empt RSS(). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Canada IC Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with 20cm between the radiator & your body.