CREATIVE MF8345 Sxfi Carrier Subwoofer User Manual
- June 5, 2024
- Creative
Table of Contents
CREATIVE MF8345 Sxfi Carrier Subwoofer
User Manual
Safety & Regulatory Information
Read this instruction carefully and completely before using the product. Refer to the following information to use your product safely, and to reduce the chance of electric shock, short-circuiting, damage, fire, hearing impairment, or other hazards. Improper handling may void the warranty for your product. For more information, read the warranty available with your product.
- Always keep the product dry and do not expose it to extreme temperatures (hairdryer, heater, extended exposure to sunlight, etc.) to avoid corrosion or deformation.
- Do not expose your product to water and moisture. If your product is moisture-resistant, take care not to immerse it in water or expose it to rain.
- Charge products with built-in rechargeable batteries at ambient temperatures between 10 and 40°C/50 and 104°F
- When not using the product for extended periods of time, charge its built-in rechargeable
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, can result in an explosion
- Leaving a battery in an extremely high temperature surrounding environment can result in an explosion or the leakage of flammable liquid or gas
- A battery subjected to the extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas
- Clean the product only with a soft, dry cloth.
- Do not dismantle or attempt to repair your product.
- Do not pierce, crush, or set fire to your product
- Keep your product away from strong magnetic objects
- Keep the product, accessories, and packaging parts out of reach of children and pets to prevent accidents. Swallowing and choking hazard.
Warning on Choking Hazard
This product and its accessories may contain small parts which must be kept away from children.
WARNING
CHOKING HAZARD-Small Parts Not for children under 3yrs.
SXFI CARRIER (MF8345, MF8370) Additional Safety and Regulatory information
The following sections contain notices for various countries.
CAUTION:
This product is intended for use with FCC/CE-certified computer equipment. Please check the equipment operating/installation manual and/or with the equipment manufacturer to verify/confirm if your equipment is suitable prior to the installation or use of the product.
Notice for the USA
Federal Communication Commission (FCC) Interference Statement
FCC Part 15: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC Rules, this device must be installed with computer equipment certified to comply with Class B limits.
All cables used to connect to the computer and peripherals must be shielded
and grounded.
Operation with non-certified computers or non-shielded cables may result in
interference to radio or television reception.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.
Federal Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body. This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
Notice for Canada
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
To comply with RSS 102 RF exposure compliance requirements, a separation distance of at least 20cm must be maintained between the antenna of this device and all persons.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.
SUPPLIER’S DECLARATION OF CONFORMITY According to CFR Title 47 §2.1077
Importer’s Name:| Creative Labs, Inc.
1901 McCarthy Boulevard
---|---
Importer’s Address:| Milpitas, CA. 95035
Tel: (408)428-6600
declares under its sole responsibility that the product
Trade Name: | Creative |
---|---|
Model Numbers: | MF8345, MF8370 |
Product Name: | Creative SXFI CARRIER, Creative SXFI |
CARRIER SUBWOOFER
EMI/EMC: ANSI C63.4 & C63.10, FCC Part 15 Subpart B & C Complies with Canadian ICES-003 Class B & RSS-247 standards
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesirable operation.
Supplementary Information:
Thinh Bui
Compliance Manager
Creative Labs, Inc.
25 October 2020
European Compliance
This product complies with all applicable directives. A copy of the EU DoC is available at the Creative website.
CAUTION: To comply with the Europe CE requirement, this device must be installed with CE-certified computer equipment which meets Class B limits.
All cables used to connect this device must be shielded, grounded, and no
longer than 3m in length.
Operation with non-certified computers or incorrect cables may result in
interference to other devices or undesired effects to the product.
MODIFICATION: Any changes or modifications not expressly approved by
Creative Technology Limited or one of its affiliated companies could void the
user’s warranty and guarantee rights.
The insulating coating on the device also serves the purpose of ESD
protection.
Vietnam RoHS Statement
This product is in compliance with Circular 30/2011/TTBCT of the Ministry of Trade of the Socialist Republic of Vietnam (“Circular”), it does not contain the following substances in a concentration greater than the Maximum Limit value as specified in the Circular.
Substance | Maximum Limit (ppm) 1, 2 |
---|---|
lead | 1000 |
mercury | 1000 |
cadmium | 100 |
hexavalent chromium | 1000 |
polybrominated biphenyls (PBB) | 1000 |
polybrominated diphenyl ethers (PBDE) | 1000 |
1Maximum Limit does not apply to applications exempted from the Circular.
2 Maximum Limit refers to concentration by weight in homogeneous materials.
SXFI CARRIER (MF8345, MF8370) Additional Safety and Regulatory information
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>