CREATIVE MF1700 Pebble V3 USB-C 2.0 Minimalist Desktop Speakers User Guide

PEBBLEv3
MINIMALISTIC 2.0 USB-C SPEAKERS
WITH BLUETOOTH® 5.0
Quick Start Guide

**Overview

**

FRONT VIEW
Disclaimer: If Pebble V3’s volume remains low when both device and speakers are at maxed volume while connected to a laptop’s USB port, connect the speakers to a 10W USB port instead of to achieve optimum volume level. 

Note: When plugged into a PC / Mac for the first time, Creative Pebble V3 will be in USB Audio mode by default. When plugged into a power source that does not support USB Audio for the first time, Creative Pebble V3 will be in Bluetooth Pairing Mode by default

REARVIEW

Setting Up Creative Pebble V3

Master Reset

|
---|---

Technical Specification

• Speaker Power: 2 x 4W RMS
• Total System Power: Up to 8W RMS, Peak Power 16W
• Drivers: 2.25” Full-range Drivers with Built-in Passive Radiators
• Wireless Technolog y: Bluetooth 5.0
• Bluetooth Profiles: A2DP (Wireless Stereo Bluetooth)
• • Wireless Type : Bluetooth Classic
• Operating RF range: 2402–2480 MHz
• Max. RF Output Power: < 4 dBm
• Input: 5V 2A
• Signal-to-Noise Ratio: 75 dB
• Frequency Response: 100–17,000 Hz
•   Connectivity: USB Audio, Bluetooth, 3.5 mm Analog Stereo-in
•  Operating Temperature: 0–45°C

Note: Up to 8W RMS when Gain is set to “High” while plugged into a 10W USB-C Port / USB-C Power Adapter / 5V 2A USB-A were Adapter *

• Adapter not included

Other Information

Please visit creative.com/compliance/pebblev3 for the user guide, safety, and regulatory information.
Please visit creative.com/support/pebblev3 for all other support related to your product.
Note: Compliance markings are located at the bottom of the product

SAFETY & REGULATORY INFOMATION

Creative Pebble V3
(Model No: MF1700)
Safety & Regulatory Information
Read this instruction carefully and completely before using the product. Refer to the following information to use your product safely, and to reduce the chance of electric shock, short-circuiting, damage, fire, hearing impairment, or other hazards. Improper handling may void the warranty for your product. For more information, read the warranty available with your product.

• Always keep the product dry and do not expose it to extreme temperatures (hairdryer, heater, extended exposure to sunlight, etc.) to avoid corrosion or deformation.
• Do not expose your product to water and moisture. If your product is moisture-resistant, take care not to immerse it in water or expose it to rain.
• Clean the product only with a soft, dry cloth.
• Do not dismantle or attempt to repair your product.
• Do not pierce, crush, or set fire to your product
• Keep your product away from strong magnetic objects
• Keep the product, accessories, and packaging parts out of reach of children and pets to prevent accidents. Swallowing and choking hazard.

Warning on Choking Hazard
This product and its accessories may contain small parts which must be kept away from children.

WARNING
CHOKING HAZARD-Small Parts
Not for children under 3yrs.
Creative Pebble V3 (MF1700) Additional Safety and Regulatory information
The following sections contain notices for various countries.
CAUTION:
This product is intended for use with FCC/CE-certified computer equipment. Please check the equipment operating/installation manual and/or with the equipment manufacturer to verify/confirm if your equipment is suitable prior to the installation or use of the product.

Notice for the USA
Federal Communication Commission (FCC) Interference Statement FCC Part 15: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC Rules, this device must be installed with computer equipment certified to comply with Class B limits.
All cables used to connect to the computer and peripherals must be shielded and grounded.
Operation with non-certified computers or non-shielded cables may result in interference to radio or television reception.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.
Federal Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co- located or operating in conjunction with any other antenna or transmitter.
Creative Pebble V3 (MF1700) Additional Safety and Regulatory information
Notice for Canada
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.

To comply with RSS 102 RF exposure compliance requirements, a separation distance of at least 20cm must be maintained between the antenna of this device and all persons.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.

SUPPLIER’S DECLARATION OF CONFORMITY
According to CFR Title 47 §2.1077

Milpitas, CA. 95035
Tel: (408)428-6600
declares under its sole responsibility that the product
Trade Name:| Creative
Model Numbers:| MF1700
Product Name:| Creative Pebble V3

has been tested according to the FCC / CISPR22 requirement for Class B devices and found compliant with the following standards
EMI/EMC: ANSI C63.4 & C63.10, FCC Part 15 Subpart B & C Complies with Canadian ICES-003 Class B & RSS-247 standards 

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesirable operation.

Supplementary Information:| Thinh Bui
Compliance Manager
Creative Labs, Inc.
23rd Jul 2020
---|---

European Compliance
This product complies with all applicable directives. A copy of the EU DoC is available on the Creative website.
CAUTION: To comply with the Europe CE requirement, this device must be installed with CE-certified computer equipment which meets Class B limits.
All cables used to connect this device must be shielded, grounded, and no longer than 3m in length.
Operation with non-certified computers or incorrect cables may result in interference to other devices or undesired effects on the product.
MODIFICATION: Any changes or modifications not expressly approved by Creative Technology
Limited or one of its affiliated companies could void the user’s warranty and guarantee rights.
The insulating coating on the device also serves the purpose of ESD protection.

Notice for Korea
Class B Equipment
(For Home Use Broadcasting & Communication Equipment)
This equipment is home use (Class B) electromagnetic wave suitability equipment and to be used mainly at home and it can be used in all areas.

China RoHS Disclosure Table

|
---|---
|
(Pb)| (Hg)| (Cd)| (Cr6+)| (PBB)| (PBDE)
| X| Ο| Ο| Ο| Ο| Ο
| X| Ο| Ο| Ο| Ο| Ο
| X| Ο| Ο| Ο| Ο| Ο
| X| Ο| Ο| Ο| Ο| Ο
| X| Ο| Ο| Ο| Ο| Ο
| X| Ο| Ο| Ο| Ο| Ο
| X| Ο| Ο| Ο| Ο| Ο
| Ο| Ο| Ο| Ο| Ο| Ο
| X| Ο| Ο| Ο| Ο| Ο

Taiwan-CNS 15663
Declaration of the Presence Condition of the Restricted Substances Marking

  Equipment name:
Type designation (Type)：MF1700

Unit| Restricted substances and its chemical symbols
Lead (Pb)| Mercury (Hg)| Cadmium (Cd)| Hexavalent chromium  (Cr6+)| Polybrominated biphenyls
(PBB)| Polybrominated diphenyl ethers (PBDE)
| –| Ο| Ο| Ο| Ο| Ο
| –| Ο| Ο| Ο| Ο| Ο
| –| Ο| Ο| Ο| Ο| Ο
| –| Ο| Ο| Ο| Ο| Ο
| –| Ο| Ο| Ο| Ο| Ο
| Ο| Ο| Ο| Ο| Ο| Ο
Note 1： “Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicates that the percentage content of the restricted substance exceeds the reference percentage value of the present condition.
Note 2：“○” indicates that the percentage content of the restricted substance does not exceed the percentage of the reference value of presence.
Note 3：The “−” indicates that the restricted substance corresponds to the exemption.

Vietnam RoHS Statement
This product is in compliance with Circular 30/2011/TTBCT of the Ministry of Trade of the Socialist Republic of Vietnam (“Circular”), it does not contain the following substances in a concentration greater than the Maximum Limit value as specified in the Circular.

The ¹Maximum Limit does not apply to applications exempted from the Circular.
²Maximum Limit refers to concentration by weight in homogeneous materials.

Notice for Australia|
---|---
Notice for Malaysia|
Notice for Singapore| Complies with IMDA StandardsDA107311

The use of the WEEE Symbol indicates that this product may not be treated as household waste. By ensuring this product is disposed of correctly, you will help protect the environment. For more detailed information about the recycling of this product, please contact your local authority, your household waste disposal service provider, or the shop
where you purchase the product.
Hereby, Creative Labs Pte. Ltd. declares the Bluetooth Speaker, model no. MF1700 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at http://www.creative.com/EUDoC
For details on the Creative Warranty period of your product, please visit https://www.creative.com/warranty
© 2020 Creative Technology Ltd. All rights reserved. Creative and the Creative logo are trademarks or registered trademarks of Creative Technology Ltd in the United Bluetooth States and/or other countries. The ® word mark and logo are owned by the Bluetooth SIG, Inc. and any use of such marks by Creative Technology Ltd is under license. All other trademarks are the property of their respective owners and are hereby recognized as such. All specifications are subject to change without notice.
The actual product may differ slightly from the images shown. Use of this product is subject to a limited warranty.

References

• Creative Worldwide SupportCreative Pebble-Plus V3
• Creative Worldwide Support
• Creative Worldwide Support - Creative Pebble V3
• creative.com/warranty
• Creative Technology - Declaration of Conformity
• creative.com/warranty
• creative.com/warranty

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>