FALCON RIDGE KAW-PROFXT-TC01 Kawasaki Pro FXT Top Cap Instruction Manual

June 3, 2024
FALCON RIDGE

FALCON RIDGE KAW-PROFXT-TC01 Kawasaki Pro FXT Top Cap

Instructions for Installation and Care

KAW-PROFXT-TC01
Notice : Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.

  1. Be sure to read these instructions thoroughly before opening and installing the Kawasaki Pro FXT Top Cap. The installation is best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if conditions prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature prior to installation.

  2. Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.

  3. Check over the parts included in the carton with the parts list shown below:
    Adhesive Velcro Hook Strips: 6 each————6”
    Top Cap
    Webbing Straps with Loop 2 each
    Webbing Straps with Velcro 4 each
    TOP CAP

  4. You have been supplied with 6 straps, but in this case you will only be using 4 of them. In this case you will be using the two straps with Velcro sewn in one end for the front and the two straps with a loop sewn in one end for the rear. The two straps with grommets in one end is only used if you are using the Top Cap with a windshield.

  5. Place the Top Cap over the vehicle with the short end towards the front. Use two of the
    6″ adhesive Velcro strips to hold the webbing straps that have the double- sided Velcro sewn to the ends. Make sure the webbing is on the outside of the bar pointed upwards. The following picture shows how this should look.

  6.  The rear of the Top Cap is held in place using the straps that have a loop sewn in one end. Take the end of the strap with the loop and put it under the bed rail just behind the support bar. Then take the other end of the strap and run it through the loop, pulling it tight. The photo below shows what it should look like.

  7.  Once all the straps are in place run them through the buckles. Pull them tight making sure the top is centered and the side seams line up correctly along the roll cage. The diagram below shows how to lace the webbing through the buckle.

  8. Once the front and rear of the Top Cap are pulled tight the next thing is to make sure the middle of the sides are attached to the 8″ adhesive Velcro on the roll cage. The photo below shows this.

Cleaning and Storage Recommendations:

  1. Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll for storage.
  2.  It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab similar to the way it was when it was packed at the factory. On a large, clean and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at a normal room temperature. It is best not to expose the Cab to either extreme hot or cold temperatures when storing.
  3. A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are needed, they can also be ordered.

Return Policy

  • If for any reason you choose to return this product it must be returned within 30 days from date item is received. You MUST package the product exactly as it was
  • originally packaged from the factory to get a full refund for the product!
  • The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between
  • and the paper (if available) on both sides of the windows.
  • All returned products will be inspected upon arrival at the production facility and must be in unused, factory new condition to receive refund – a 25% restocking fee will
  • apply.
  • If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item
  • is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a
  • 20% restocking fee. If ordered from one of Falcon Ridges many distributors’, you must first call them and see what their return policy is. Once your item reaches our
  • production facility, our customer satisfaction team will inspect your item to ensure unused, factory new condition. NOTE: All windshields must be returned with the
  • original protective film intact and not removed. Do NOT REMOVE if you have any intentions of returning the item. Refund/ replacement of a windshield will only be
  • processed on items with original protective film or if the windshield is defective.
  • Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new
  • resalable condition (any returned items that have been used, altered or damaged in any way will not be subject for a refund.) All contents including instruction manuals,
  • accessories, hardware, Velcro, etc. must be included in your return shipment. Only items in OEM factory new condition will be approved. Once returned items are received,
  • credit will be issued to the original credit card/ payment  method used for the purchase. Outbound shipping and return shipping cost will not be refunded.Please allow 4 to
  • 6 weeks for your refund to be processed.

Warranty

To The Owner of this Product:
Thank you for purchasing one of Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product. Please refer to the return policy in this case for more information. 1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.

Thank you, Falcon Ridge

Documents / Resources

| FALCON RIDGE KAW-PROFXT-TC01 Kawasaki Pro FXT Top Cap [pdf] Instruction Manual
KAW-PROFXT-TC01, Kawasaki Pro FXT Top Cap, KAW-PROFXT-TC01 Kawasaki Pro FXT Top Cap, FXT Top Cap, Top Cap
---|---

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

FALCON RIDGE User Manuals

Related Manuals