FALCON RIDGE BC-3400-WD05 Bobcat 3400 Aero-Vent Polycarbonate Windshield Instruction Manual
- October 27, 2023
- FALCON RIDGE
Table of Contents
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Bobcat 3400
Aero-VentPolycarbonate Windshield
BC-3400-WD05 / 50-40046
BC-3400-WD05 Bobcat 3400 Aero-Vent Polycarbonate Windshield
NOTICE: Please check contents of package for any damage and make sure all
parts fit correctly and you are happy with the product before removing
protective film. Once the film is removed you cannot return the product for a
full refund.
Be sure to read these instructions thoroughly before opening and installing
the Polycarbonate Windshield.
- Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Check over the parts included in the cartons with the parts list shown below:
1 ¾” Loom Clamps| 8 each
---|---
1” Stainless Steels Bolts| 14 each
Stainless Steel Washers| 20 each
Slide fasteners| 8 each
Lock Nuts| 4 each
Plastic Thumb Nuts| 10 each
Sliding Vent Panels| 2 each
52” Rubber Gasket| 1 each
55” Rubber Gasket| 1 each
BentPolycarbonate Braces| 1 each
Polycarbonate Windshield| 2 Pieces
If any parts are damaged or missing please contact customer service at (606) 845-7439.
-
Next take the rubber gasket and starting at one end firmly place along entire bottom and top edges of the lower Windshield Section. You will need to peel back the protective film from the edge to install the gasket. If you leave the bulk of the protective film on while installing you can keep from scratching the windshield. Please see photo below:
-
Next Install the Aero-Vent sliders as shown in the diagram on the following page.
-
Next take the bent Polycarbonate brace and install it on the windshield. Please see diagram on the next page.
-
Now you are ready to place the windshield on the Bobcat and attach to the roll cage. NOTE: THE BEND AT THE TOP OF THE WINDSHIELD SHOULD GO BELOW THE TOP TUBE. The diagram on the next page shows the proper placement for the hardware. Install the clamps as shown for the top two slots in the windshield only. Use the 1” bolts for this application.
-
Now Place the two halves onto the frame as shown on the next page. (diagram not Bobcat)
-
Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of some sort to decrease the chance of scratches. We recommend using micro fiber cloths that are readily available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.
Thank you for your purchase!
Warranty
To The Owner of this Product:
Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or
Windshields! Below are the terms under which your product is covered under our
manufacturer’s warranty.
30 Day Warranty which includes and is not limited to replacing the enclosure,
tops and/or windshield due to defect of the product. Please refer to the
return policy in this case for more information.
1 Year Warranty includes any defect in material or workmanship within this
time frame we will gladly correct the problem or replace the enclosure, tops
&/or windshield. Upon submitting for the correction or replacement we will
need to receive pictures of the defect in material or workmanship along with
the receipt from the date of purchase.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>