CREATIVE EF0910 Outlier Gold V2 True Wireless Sweatproof In-Ears Headphones User Guide

: June 5, 2024
: Creative

Table of Contents

CREATIVE EF0910 Outlier Gold V2 True Wireless Sweatproof In-Ears
Overview
Technical Specifications
2. Controls
Earbuds Fit Guide
Master Reset
Overview
Controls
Master Reset
WORLDWIDE WARRANTY
Safety & Regulatory Information
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

CREATIVE EF0910 Outlier Gold V2 True Wireless Sweatproof In-Ears

Headphones

CREATIVE EF0910 Outlier Gold V2 True Wireless

Overview

Technical Specifications

Headphones drivers

5.6 mm Graphene-enhanced Driver
Frequency Response: 20–20,000 Hz
Microphones
Type: Omni-directional x4
Frequency Response: 100–10,000 Hz
Sensitivity (1 kHz): -42 dBV / Pa
Interface
USB Type-C (charging), Bluetooth 5.0

Bluetooth profiles

A2DP (Wireless stereo Bluetooth)
AVRCP (Bluetooth remote control)
HFP (Hands-free profile)

Wireless operating range

Up to 100m
RF Output Power: < 20 dBm
Operating Frequency: 2402–2480 MHz

Battery

Earpiece (Left and Right) Lithium-ion polymer battery: 3.7V 80 mAh 0.296 Wh
Battery charging case Lithium-ion polymer battery: 3.7V 900 mAh 3.33 Wh Input: 5V 1A
Total play time
Up to xx hours
Charging time
1–2 hours
Audio codec
SBC, aptX™, AAC Operating temperature
0–45°C

Note: Compliance markings are located at the bottom of the product

2. Controls

CREATIVE EF0910 Outlier Gold V2 True Wireless -fig 2

Earbuds Fit Guide

Master Reset

Overview

Charging Case Battery Indicator
i) Charging Indicator
Charging – Glowing Red
Fully charge – Solid Green
ii) Battery Level
Low – Red
Medium –Yellow
High – Green
Left Earbud Charging Indicator
Right Earbud Charging Indicator
iii) Earbuds Charging Indicator Charging – Glowing Red Optimally Charged – Solid Green Fully Charge – LED Off
USB-C Charging Port
Earbud LED Indicator
iv) Slow Blinking Blue – Disconnected
v) Flashing Red / Blue – Bluetooth Pairing
vi) Glowing Red (In Charging Case) – Charging

Controls

Playback Mode
Pause Mode
Call Mode
Earbuds On (Bluetooth Disconnected) Note: When a long press is initiated, earbud will first enter Bluetooth Pairing Mode before turning off. Each earbud will need to be turned off manually.
Earbuds Off

Earbuds Fit Guide
Gently push and wiggle the earbuds into the respective ear canals until a good seal is made to ensure proper fitting

Master Reset

Earbuds will flash once in blue in charging case when Master Reset is complete. Master Reset is reserved for cases where users encounter issues while earbuds are in use or during situations such as: Bluetooth Pairing failure, random LED flashing, failure to pair secondary earbud with the main earbud, or to reset all data

Creative True Wireless Stereo Earbuds: Common connectivity issues
SUMMARY:
This article highlights a phenomena and recommendation for music cuting out and ear buds that do not stay connected.
When pairing a smart mobile device with TWS (True Wireless Stereo) ear buds, the signal is strongest when there is a line-of-sight between the pairing devices.

If the signal passes through the body, which is mostly made up of water fluid, it may get absorbed, which may result in pairing difficulty. If the mobile device is already connected to the TWS ear buds, it may result in signal lost or the ear buds may get disconnected.
Therefore, it is recommended to place the smart mobile device on the same side as the main connected ear bud; thereby bypassing the body barrier. For example, left ear bud is paired as the main connected ear bud, the smart mobile device should be placed in the left pocket of your pants and vice versa.

Please visit creative.com/compliance/outliergoldv2 for the user guide, safety and regulatory information, ErP information where applicable and battery removal instruction which is meant strictly for independently qualified professional.
Please visit creative.com/support/outliergoldv2 for all other support related to your product.

WORLDWIDE WARRANTY

Creative warrants that the accompanying product is free from material or workmanship defects for a period of 12 months (non-transferable Creative Warranty period) from your purchase date. In the event of a genuine product failure, Creative will assume repair or part replacement (new or refurbished) within the Creative Warranty period. However, this Creative Warranty does not cover (among other things) consumable parts, such as batteries or protective coatings that, due to their nature, tend to diminish over time, normal wear and tear, abnormal usage, improper storage and handling, unauthorised modifications or repair, damages arising from an Act of God and theft. In the event of a genuine product failure you must provide Creative with the product and proof of purchase of the product by a dated itemised receipt. This is a only a summary of the Creative Warranty terms.

For the full details on the Creative Warranty period of your product, Creative Warranty terms, product returns and repair procedure, and Creative Customer Support services and contact information, you are advised to refer to the full version of the Creative Warranty at Web site http://creative.com/warranty

We also recommend you to register your product with us at www.creative.com/register to enjoy a host of additional product benefits that includes latest news and promotions. Note that your entitlement to the Creative Warranty is not dependent on product registration.
NOTE: This warranty gives you specific legal rights. You may have other rights, which vary from country to country. Certain limitations in this warranty are not permitted by the jurisdiction of some countries, so some limitations here may not apply to you.

Safety & Regulatory Information

Read this instruction carefully and completely before using the product. Refer to the following information to use your product safely, and to reduce the chance of electric shock, short-circuiting, damage, fire, hearing impairment or other hazards. Improper handling may void the warranty for your product. For more information, read the warranty available with your product.

Always keep the product dry and do not expose it to extreme temperatures (hairdryer, heater, extended exposure to sunlight, etc.) to avoid corrosion or deformation.
Do not expose your product to water and moisture. If your product is moisture-resistant, take care and not to immerse in water or expose to rain.
Charge products with built-in rechargeable batteries at ambient temperatures between 10 and 40°C/50 and 104°F
When not using the product for extended periods of time, charge its built-in rechargeable battery regularly (about every 3 months).
Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion
Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas
A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas
Use only attachments/accessories/spare parts supplied or recommended by Creative
Do not insert the earphones too deep into your ears and never insert them without ear adapters. Always remove the earphones slowly and carefully from your ears.
Clean the product only with a soft, dry cloth.
Do not dismantle or attempt to repair your product.
Do not pierce, crush or set fire to your product
Keep your product away from strong magnetic objects
Keep the product, accessories and packaging parts out of reach of children and pets to prevent accidents. Swallowing and choking hazard.

Warning on Choking Hazard
This product and its accessories may contain small parts which must be kept away from children.

WARNING

CHOKING HAZARD – Small Parts Not for children under 3yrs.

The following sections contain notices for various countries.

CAUTION:

This product is intended for use with FCC/CE certified computer equipment. Please check the equipment operating/installation manual and/or with the equipment manufacturer to verify/confirm if your equipment is suitable prior to the installation or use of the product.

Notice for USA
Federal Communication Commission (FCC) Interference Statement
FCC Part 15: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if no installed and used in accordance with instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.

CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC Rules, this device must be installed with computer equipment certified to comply with Class B limits.
All cables used to connect to the computer and peripherals must be shielded and grounded. Operation with non-certified computers or non-shielded cables may result in interference to radio or television reception.

MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the device.

Federal Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC ID:2AJIV-EF0910LR (For Earpiece)
Creative Outlier Air V2 (EF0900) Additional Safety and Regulatory information

European Compliance
This product complies with all applicable directives. A copy of the EU DoC is available at Creative website.

CAUTION: To comply with the Europe CE requirement, this device must be installed with CE certified computer equipment which meet with Class B limits.
All cables used to connect this device must be shielded, grounded and no longer than 3m in length. Operation with non-certified computers or incorrect cables may result in interference to other devices or undesired effects to the product.

MODIFICATION: Any changes or modifications not expressly approved by Creative Technology Limited or one of its affiliated companies could void the user’s warranty and guarantee rights.
The insulating coating on the device also serves the purpose of ESD protection.