FALCON RIDGE PO-10MIDRANGER-RW01 Mid Size Polaris Ranger Soft Rear Panel Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of
Polaris Ranger 400/500
Soft Rear Window
PO-10MIDRANGER-RW01
PO-10MIDRANGER-RW01 Mid Size Polaris Ranger Soft Rear Panel
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. The cab is Flammable.
- Be sure to read these instructions thoroughly before opening and installing the Polaris Ranger Cab Enclosure. The installation is best done when the temperature is 70 degrees F. or warmer. This is to allow the Velcro to stick to the roll cage better, if you must install it outside in the cold it will help to warm the Velcro inside at room temp. until ready to install.
- Carefully open the carton and remove the rolled Cab Enclosure on a large flat surface that is clean and free of dirt or other material that may soil or scratch the windows of the Cab.
- It will help to raise the bed prior to installing the cab enclosure.
- Check over the parts included in the carton with the parts list shown below:
Velcro Hook strips:
“ “
“ “
“ “
Cab Enclosure| 12 each
1 each
1 each
1 each| 3” long
30” long
52” long
---|---|---
- Begin by raising the bed of the Ranger and cleaning the metal piece that runs along the bottom. After cleaning it off affix the 52” adhesive Velcro strip centered along the back at the bottom. Then clean the area along the top of the roll cage that runs from side to side and place the 30” adhesive Velcro tab centered and facing the front of the Ranger. Now place the rear window up and attach the top to the Velcro there and pull the bottom down and attach the Velcro centered along the bottom.
- The sides are attached using double-sided Velcro strips sewn along the edges of the rear window. At each of the straps use one of the supplied 3” adhesive strips and place it on the inside of the roll cage so that the double-sided pieces hold onto it when wrapped around the bar. The following diagrams show how this works.
Cleaning and Storage Recommendations:
-
Before removing the Falcon Ridge Cab for storage, make sure it is very clean in order to prevent scratching of the window panels. Clean with a soft rag or sponge using a mild liquid detergent soap and warm water solution. Never rub the windows with a dry cloth or rag! Let the Cab dry thoroughly before attempting to roll it for storage.
-
It is important that the Cab be rolled up for storage rather than folding. Folding will cause damage to the windows!!! Carefully roll up the Cab like the way it was when it
was packed at the factory. On a large, clean, and flat surface, fold the doors over the rear panel first, then, interleave the top and windshield on top of the doors. Begin rolling the Cab into a roll approximately 8 inches in diameter. Put the rolled Cab back into the carton for storage at normal room temperature. It is best not to expose the Cab to either extremely hot or cold temperatures when storing. -
A special cleaner conditioner is available from Falcon Ridge that will greatly increase the service life of the Cab Enclosure. In addition, if additional hook and loop sets are
needed, they can also be ordered.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>