DIGITUS DS-30220-5 PCIE Card USB 3.0 2 Port Self Power User Manual
- June 5, 2024
- DIGITUS
Table of Contents
DIGITUS DS-30220-5 PCIE Card USB 3.0 2 Port Self Power
Features
- Fully compliant with PCI Express Base Specification Revision 2.0
- Single-lane (x1) PCI Express throughput rates up to 5 Gbps
- Compliant with Universal Serial Bus 3.0 specification Revision 1.0
- Supports simultaneous operation of multiple USB 3.0, USB 2.0 and USB 1.1 devices supporting the following speed data rates as follows: Low-speed (1.5Mbps) / Full-speed (12Mbps) / High-speed (480Mbps) / Super-speed (5Gbps)
- Supports 2 downstream ports for all speeds
- Each USB port supports Power supply 5V/3A output by itself
- Hot-swapping feature allows you to connect/disconnect devices without powering down the system
- Support Windows® XP/Vista/7 (32/64 bit), Linux
System Requirements
- Windows® XP/Vista/7/8/8.1/10/11 (32/64 bit)
- One available PCI Express slot (Recommend PCI Express 2.0)
Package Contents
- 1 x USB 3.0 2-Port PCI Express Card
- 1 x Driver CD
- 1 x User Manual
Hardware Installation
- Turn Off the power to your computer.
- Unplug the power cord and remove your computer’s cover.
- Remove the slot bracket from an available PCIe slot.
- To install the card, carefully align the card’s bus connector with the selected PCIe slot on the motherboard. Push the board down firmly.
- Replace the slot bracket’s holding screw to secure the card.
- Replace the computer cover and reconnect the power cord.
Driver Installation
For Windows® XP/Vista/Win7 (32/64 bit)
- Please insert the CD driver bound with USB 3.0 2-Port PCI Express Card into your CD-ROM Drive.
- At the Windows desktop, click Start, Run.
- Type D: \ USB3.0 NEC D720201-202\EXE \Setup.exe, click OK. (Change D: to match your CD-ROM drive letter)
- Follow the on-screen instructions to complete the installation.
To Verify Driver Installation
- Click on the “Device Manager” tab in System Properties, which you access from the Windows Control Panel. You should see a “Renesas Electronics USB 3.0 Host Controller” and a “Renesas Electronics USB 3.0 Root Hub” under the “Universal Serial Bus controllers” item.
Hereby ASSMANN Electronic GmbH declares that this device is in compliance with the requirements of Directive 2014/30/EU and Directive 2011/65/EU for RoHS compliance. The complete declaration of conformity can be requested by post under the below-mentioned manufacturer address. Warning: This device is a class B product. This equipment may cause some radio interference in the living environment. In this case, the user can be requested to undertake appropriate measures to prevent interference.
- www.assmann.com
- Assmann Electronic GmbH
- Auf dem Schüffel 3
- 58513 Lüdenscheid
- Germany
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>