Kogan KASTKSTM06A 6-IN-1 STEAM STICK User Guide
- June 5, 2024
- Kogan
Table of Contents
User Guide
6-IN-1 STEAM STICK
KASTKSTM06A
SAFETY & WARNINGS
WARNING: To reduce the risk of fire, electrical shock, or injury, the following basic safety precautions should always be followed when using an electrical appliance.
-
Read all instructions before using the appliance and retain them for reference.
-
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they
have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety. -
This product is suitable for indoor use only.
-
Do not use with an extension cord unless necessary and if so, ensure it is suitably rated and it is handled safely as is the product’s power cord.
-
Do not allow the power cord to be exposed to water, heat, direct sunlight or overhang where it can be pulled or otherwise be damaged or pose a hazard.
-
To reduce the likelihood of circuit overload, DO NOT operate another high wattage appliance on the same circuit as this unit.
-
Always set the steam adjustment dial to the “Off” position before plugging or unplugging the appliance.
-
Any appliance is electrically live even when the switch is off. To reduce the risk of electrical shock:
o Always unplug the power cord immediately after use.
o, Do not place or store unit where it can fall or be pulled into a sink or tub.
o, Do not immerse this product in water or any other liquid.
o If the unit falls into water, immediately unplug the power cord. Do not reach into the water. -
Do not use the unit where aerosol-based products are being used or where oxygen is
being administered. -
Steam can cause injury or damage. Take care where steam is directed, especially when powering on the appliance and using steam on surfaces for the first time.
-
Burns can occur from touching hot metal parts, hot water, or steam. Do not touch the Steam Nozzle or attempt to connect accessories while the unit is in use.
-
Use caution when emptying the water tank after use, as the water in the unit may be hot.
-
It is not recommended that this unit be used on an unsealed floor. Use care when steaming floors that may be warped or damaged by heat and moisture, and limit use of this unit on these types of surfaces.
-
Steaming unsealed floor surfaces such as hardwood is not recommended and may result in warping or damage to the surface.
-
Always allow the appliance to cool completely (at least 5 minutes) before storing. Follow instructions in the Cleaning & Care section of this user guide.
-
This appliance contains no user-serviceable parts. If it suffers any failure or damage, cease use and contact help.kogan.com before further use.
OVERVIEW
1 Water tank
2 Steam button
3 Steam level indicator
4 Main body
5 Upper release button
6 Extension rod
7 Lower release button| 8 Mop head
9 Nylon brush
10 Brass brush
11 Measuring cup
12 Steam nozzle
13 Window Tool
14 Microfiber pads
---|---
ASSEMBLY
Steam Nozzle
Align the steam nozzle with the head of the main unit, then rotate it until
the steam nozzle is firmly locked into position.
Attaching Accessories
Firmly attach the desired accessory to the steam nozzle until it is locked in
place. Ensure the orientation of the elbow directs the steam downwards.
Installing Extension Rod and Mop Head
When cleaning high, out-of-reach places or mopping the floor, the extension
rod and mop head should be used.
Extension Rod:
Align the extension rod with the nozzle on the main body, hold down the upper
release button and gently rotate the extension rod until it ‘clicks’ firmly in
place.
Mop Head:
Align the extension rod with the mop head, hold down the lower release button
and gently rotate the extension rod until it ‘clicks’ firmly in place.
Note: The mop head can also be connected directly to the main body.
Installing Microfibre Pads
- Lay the microfibre pad on a flat surface with the two fastener strips facing upward.
- Align the mop head above the microfiber pad. Ensure the mop head is oriented with the pads as shown below.
- The fastener strips will adhere to the grips on the bottom of the mop head.
OPERATION
Filling the Water Tank
- Ensure the steam mop is turned off and unplugged from the outlet.
- Unscrew the water tank cap and use the measuring cup to fill the water tank with water. Do not overfill the water tank. Hold the main body level while filling.
- Replace the cap, ensuring it is pushed down firmly to create a tight seal.
Notes:
In order to significantly reduce mineral build-up and prolong the life of the
device, the use of distilled or de-mineralized water in the unit is highly
recommended.
Starting the Steam Mop
- Make sure the device has been filled with water before turning it on. Do not run dry.
- Plug the power cord into a power outlet and switch it on.
- Wait about 20 seconds until the middle indicator turns solid.
- Press the steam button to release steam.
- Press and hold the steam button for 2-3 seconds to turn off the steam.
Notes:
- The steam button is used to control steam levels and will not turn off the steam mop. Disconnect the cord from the power outlet after each use.
- Do not aim the steam at pets, plants, or any other electrical appliances during use to avoid burns or damage to the machine.
- Before storing the steam mop, remove the water tank before turning off the power, and then let the product run for a while until there is no steam.
Steam Cleaning
- Ensure your desired attachment is already connected to the unit.
- Connect the steam nozzle when steam cleaning to ensure the steam is more concentrated and effective.
- Press and hold the steam button for 2-3 seconds to turn off the steam.
- It is recommended to use the MAX level for the steam cleaning function.
Mop Cleaning
-
Whenever the steam mop has been used for an extended time or when the mop is too wet or dirty, it must be cut off before it can be replaced.
Note: When changing the mop attachments, be careful not to touch the steam mop outlet with your hands to avoid burns. -
It is recommended to use the middle level for the steam mop cleaning function.
Note:
Do not let the steam mop operate without water, doing so may cause damage to
the machine.
WARNING:
- To avoid overheating, please unplug the unit when not in use. The steamer will remain hot until unplugged.
- If using for a long period, ensure the steamer is stopped every 10 minutes to allow the unit to cool down. Using for more than 10 minutes at a time may result in overheating and damage.
CLEANING & CARE
IMPORTANT: Allow the steamer to completely cool down before performing
any maintenance or troubleshooting checks.
Maintenance
This product contains no user-serviceable parts. Do not attempt to repair it
yourself. Any servicing that requires disassembly other than cleaning must be
performed by a qualified appliance repair technician.
Cleaning the Microfiber Pads
- Machine washable on a “warm” setting using a mild detergent.
- For best results, lay flat to dry after cleaning.
- Do not use bleach or fabric softener when washing the microfibre cleaning pads.
Storage
- After the steamer is used, turn the power off and then unplug the power cord.
- Clean the external surface with a dry cloth.
- Remove the cleaning pad and wash it so that it will be ready for the next use.
- Store the product in a clean and dry area out of reach of children.
SPECIFICATIONS
Rated Voltage
Rated power
Rated Frequency
Tank Capacity
Operating time| 220-240V
1200W
50/60Hz
0.25L
10-25min
---|---
FAQ
The steam mop is not heating.
Check the steam mop is properly connected to the power outlet.
The machine does not emit steam.
- Check that the water tank has enough water in it.
- Ensure the ball in the water tank is fully immersed in water
The machine leaked a lot of water
The steam position is not set properly. Press the steam switch button to
adjust the steam level until it is not spraying water.
Note: We recommend using MAX level for steam cleaning function, connect the steam jet to the nozzle on the main nozzle when steam cleaning, steam will be more concentrated and powerful.
Note: We recommend using the middle level for the mop cleaning function. It is normal to see water droplets due to the condensation caused by the steam mop.
Need more information?
We hope that this user guide has given you
the assistance needed for a simple setup.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>