Ciro 66100 Tie Down Brackets Instructions
- June 5, 2024
- Ciro
Table of Contents
Tie Down Brackets for Road Glide
WARNING This indication alerts you to the fact that ignoring the contents described herein can result in potential serious injury or death if not followed. CAUTION This indication alerts you to the fact that ignoring the contents described herein can or will result in material damage and/or personal injury. ATTENTION This indication alerts you to the fact if you ignore this detail you will affect the performance or functionality of the product.
All Ciro products are designed for “easy assembly” and/or “plug and play”. We
recommend a competent mechanic install our products, using standard mechanical
procedures to assure a safe and successful installation. Read completely and
understand the instructions prior to starting installation.
NOTE: Ciro products are designed and manufactured under very strict
quality control. Ciro warrants that products sold to the original purchaser
shall be free from any defects in materials and workmanship for a period of 3
(three) years from the date of purchase, and a lifetime warranty against LED
failure. Ciro will have no obligation if the customer cannot show proof of
purchase. Warranty will not be granted unless the part is properly installed
and maintained. Ciro will not be liable for any consequential and incidental
damages, including labor, or non-Ciro products. Please visit Ciro3d.com for
our complete warranty policy.
Items Included:
| 1 | Left tie down bracket |
|---|---|
| 2 | Right tie down bracket |
| 3 | 5/16-18 x 1” Screw |
| 4 | 5/16” Washer |
Installation Instructions:
- Park on a level surface, allow the vehicle to cool.
- Starting with one side of the motorcycle, turn the handlebars so that the two Torx head screws on the side of the fork are accessible between the fuel tank and fairing. A long ratchet extension will be needed to avoid hitting the fairing or fuel tank. Fig.1, Fig.2.
- Remove the upper and lower Torx head screws. Retain the washers for re-use, the screws will not be resued.
- Install the tie-down brackets using the supplied screws and washers. The previously removed washers will be used between the tie-down brackets and the forks as spacers. The tie-down loop is positioned forward and outward of the motorcycle. Fig. 3.
- Tighten the two screws to 10-15 ft-lbs (120-180 in-lbs).
- Turn the handlebars side to side to both steering locks checking clearances to all components.
- Repeat process on other side.
TIPS FOR USING TIE DOWN BRACKETS:
Use high-quality tie-down straps that are in good condition. Read and
understand their load ratings. Use tie down straps that are correct for the
job. Cam or ratchet are both acceptable. Secure the front wheel straight ahead
and prevent forward movement. A wheel chock can be helpful. Locate appropriate
mounting points on the trailer. The mounting points should be in front of the
motorcycle’s front axle and behind the front of its tire and evenly spaced
24-36 inches wide. Do not overtighten the straps. The front suspension should
only compress enough to keep the straps tight. One or two inches of suspension
compression is enough. Stabilize the rear of the motorcycle. Do not
overtighten the straps.
G0066100, REV._
For the latest version of installation instructions visit
www.ciro3d.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>