G0050311 Ciro Accessory Perch Mount Instruction Manual
- June 5, 2024
- Ciro
Table of Contents
G0050311 Ciro Accessory Perch Mount
Parts included
- Perch Mount
- Installation Kit
- 2 1/4-20 SHCS
- 2 M6 SHCS
- 2 Spacers
Park on a level surface and shut off the motorcycle. Ensure that the engine has time to cool before installation. Cover your tank with a clean towel or blanket to protect it. Determine which side of the handlebars you would like the mount. Remove the two screws holding the clamp half in place. Carefully support the original clamp half and controls to prevent any accidental damage.
Compare the screws you removed to the screws included in this kit. Both 1/4-20 and M6x1.00 threaded screws areincluded to cover a variety of applications. Use the screws that match your motorcycle. Prepare the perch mount.
Install the perch mount with spacers to the motorcycle, making sure to re-use the original clamp half. Tighten to factory specifications; approximately 72-108 in-lbs 8.1-12.2 Nm.
The position of the top ball can be adjusted to provide adequate clearance for
any installed accessory. Use a 5/32 hex key to loosen and adjust the position,
checking final tightness before riding. If you have purchased any Ciro
accessories to go with your ball mount, please refer to those instructions to
complete
your installation
SMART PHONE HOLDER
INSTALLATION INSTRUCTION
WARNING
This indication alerts you to the fact that ignoring the contents described
herein can result in potential serious injury or death if not followed.
CAUTION
This indication alerts you to the fact that ignoring the contents described
herein can or will result in material damage and/or personal injury.
ATTENTION
This indication alerts you to the fact if you ignore this detail you will
affect the performance or functionality of the product. All Ciro products are
designed for easy assembly and/or plug and play. We recommend a competent
mechanic install our products, using standard mechanical procedures to assure
a safe and successful installation.
NOTE:
Ciro warrants that products sold hereunder to the original purchaser, if
maintained and operated under normal conditions, shall be free from any
defects in materials and workmanship for a period of 3 years from date of
purchase, and a lifetime warranty against LED failure. Ciro will have no
obligation if the customer cannot show proof of purchase. Warranty will not be
granted unless the part is properly installed and maintained. Ciro will not be
liable for any consequential and incidental damages, including labor, or non
Ciro products. Please visit our website Ciro3d.com for
our complete warranty policy.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>