Saramonic UwMic10 HU10 Handheld Microphone Instructions
- June 6, 2024
- Saramonic
Table of Contents
-
Windscreen and pop filter
-
Display
-
Power switch/Frequency adjustment
-
Battery cover
-
Transmission antenna
-
Connect the receiver to a power outlet through the power adapter provided and turn on the receiver.
-
Put two alkaline AA batteries into the battery compartment of the microphone. Please ensure the positive and negative ends are positioned in the correct direction.
-
Power on the handheld microphone. In case of any frequency interference, press the set button can choose different frequencies. There are up to eight frequencies to choose from.
-
Please note that it will take a few seconds for the receiver to automatically syndicate the frequency will be changed after the set button each pressed
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
–Reorient or relocate the receiving antenna. –Increase the separation between
the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>