CAL-ROYAL BW-302 Weather Seal Door Accessories Installation Guide
- June 5, 2024
- CAL-ROYAL
Table of Contents
BW 302 Weather Seal Door Accessories
Installation Guide 
ITEM/FINISH:
BW-302
LENGTH: 36” & 48″ NYLON BRUSH MILL FINISH ALUMINUM &
DURO
Packaging includes:
– Screws for wood and metal doors
Installation Guidelines:
CUTTING BRUSH:
- Detach brush prior to trimming.
- Cut off extra brush using a cutting tool (lineman side cutting pliers) and crimp the brush strand ends.
- Re-install the brush until it is level with one end of the retainer and crimp to hold it in place.
DOOR BOTTOM RETAINER:
- Determine the required length, mark, and cut the door bottom sweep to the full width of the door.
- When trimming, remove parts of the brush seal to be trimmed and use a cutting tool (lineman side cutting pliers) to compress the end of the seal. This will retain the brush. Trim the aluminum retainer with a hacksaw.
- Close the door and place the door bottom sweep along the outside bottom edge of the door so that it makes contact with a threshold. Mark door in the center of slotted holes.
- Drill pilot holes in the door at marks.
- Fasten door bottom sweep to door with screws.
- Adjust to ensure firm contact with threshold/above the finish floor.
Tools Required:
- Power tool drill
- Marker
- Caulking gun
- Measuring tape
- Screwdriver
- Cutting tools (hacksaw & plier)
Fastener :
Screws Size – #6 x 5/8″ PPHSMS
TESTING/RATINGS:
Gasketing material for fire doors intended for application to UL listed steel frames and/or classified steel covered composite type, and hollow metal type fire doors rated up to 3hrs; wood and plastic covered composite type fire doors rated up to 1-1/2 hrs, and wood core type fire doors rated up to 20 minutes. 43ZY
Important Reminder: Always use appropriate Personal Protective Equipment (PPE) during installation.
6605 Flotilla Street, City of Commerce, CA 90040 U.S.A.
Website: www.cal-royal.com
Email: sales@cal-royal.com
Phone: 323-888-6601 ;
800-876-9258
Fax: 323-888-6699 ;
800-222-3316