CAL-ROYAL ALBRF2260V Fire Vertical Rod Exit Device Installation Guide
- May 15, 2024
- CAL-ROYAL
Table of Contents
CAL-ROYAL ALBRF2260V Fire Vertical Rod Exit Device
NOTE
ALL FIRE-RATED APPLICATIONS ARE REQUIRED TO USE THE SEX BOLTS.
BEFORE INSTALLING THE DEVICE, PLEASE CHECK:
- IF THE DOOR FITTED AND HUNG.
- SIZE OF EXIT DEVICE, FUNCTION AND DESIGN…
- 36 “DOORS, CAN BE CUT TO FIT DOORS DOWN TO 30” WIDE.
- 48 “DOORS, CAN BE CUT TO FIT DOORS DOWN TO 36” WIDE.
- HAND OF DEVICE AGAINST APPLICATION
- TO CHANGE THE HAND OF THE DEVICE.
- USE PIN, 2-1/4″ LONG, TO KNOCK OUTLIFT LEVER PIN.
- REMOVE THE LIFT LEVER AND REASSEMBLE LE OTHER END.
NOTE
ALL FIRE-RATED APPLICATIONS ARE REQUIRED TO USE THE SEX BOLTS
- MARK VERTICAL AND HORIZONTAL
- REFERENCE LINE ON DOOR.
DETERMINE THE BACKSET TO LOCATE THE VERTICAL REFERENCE LINE.
- IF THE LOCK STILE IS 4 1/2″ WIDE OR WIDER, THE BACKSET IS 2 3/4″.
- IF LOCK STILE IS LESS THAN 4 1/2″ WIDE, BACKSET
- IS HALF OF THE EXPOSED WIDTH OF THE LOCK STILE.
PREPARE DOOR
- TAPE TEMPLATE ON INSIDE OF DOOR ALONG REFERENCE LINE.
- SPOT AND DRILL HOLE.
APPLY TRIM + CHASSIS
ATTACH TOP AND BOTTOM CHASSIS
- MOUNT TOP STRIKE PER LOCATION IN 2ND STEP.
- SCREW TOP ROD INTO MAIN SLIDE.
- SLIDE GUIDE AND COVER ONTO TOP ROD AND ASSEMBLE CHASSIS BY ADJ PIN. THROUGH THE RETRACTOR AND MIDDLE HOLE IN THE ROD.
- (SEE FIG AT LEFT) ADJ TOP CHASSIS MOUNTING HOLES LINE UP WITH THE LOCATION MARKED IN 2ND. STEP.
- FASTEN GUIDE. IF A SHORTER ROD IS REQUIRED, CUT TO LENGTH AND DRILL A 1/8″® HOLE THROUGH.
- APPLY AUX FIRE LATCH ASSY PER ATTACHED TEMPLATE FOR AUX FIRE LATE
APPLY RAIL ASSEMBLE
- CHECK THE SIZE OF THE DEVICE, IF CUTTING TO LENGTH IS REQUIRED.
- DETERMINE THE CUT-OFF LENGTH “X” BY SUBTRACTING 1 3/4″ FROM “Y”. MARK THE CUT-OFF POINT ON THE MOUNTING RAIL.
- DRESS ARM INTO RAIL OPENING AND SLIDE RAIL ONTO CHASSIS. LEVEL RAIL AND FASTEN CHASSIS AND MOUNTING.
APPLY COVER
EDG-4096-10/23-2of2
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>