CAL-ROYAL BTN-133 Door Bottom Sweep Installation Guide
- June 5, 2024
- CAL-ROYAL
Table of Contents
CAL-ROYAL BTN-133 Door Bottom Sweep
Door Bottom Sweep
Installation Guidelines:
- Determine the required length, mark and cut the the door bottom sweep to full width of the door.
- Close the door and place door bottom sweep along outside bottom edge of door so that it makes contact with threshold. Mark door in center of slotted holes.
- Drill pilot holes in door at marks.
- Fasten door bottom sweep to door with screws.
- Adjust to ensure firm contact with threshold / above finish floor.
TESTING/RATINGS:
Gasketing material for fire doors intended for application to UL listed steel
frames and/or classified steel covered composite type, and hollow metal type
fire doors rated
up to 3hrs; wood and plastic covered composite type fire doors rated up to
1-1/2 hrs; and wood core type fire doors rated up to 20 minutes. 43ZY
Tools Required:
- Power tool drill
- Marker
- Caulking gun
- Measuring tape
- Screw driver
- Cutting tools (hacksaw & plier)
Packaging includes:
– Screws for wood and metal doors
Fastener :
Screws Size – #6 x 5/8″ PPHSMS
HINT: “Where to install door sweep?”
Door sweeps are installed on one side of a door to keep out cold drafts. It
should be installed on the inside bottom edge of doors that swing into the
house, and on the outside bottom edge of doors that swing outwards.
Important Reminder: Always use appropriate
Personal Protective Equipment (PPE) during installation.
6605 Flotilla Street, City of Commerce, CA 90040 U.S.A.
Website: www.cal-royal.com | Email: sales@cal-
royal.com
Phone: 323-888-6601 ;
800-876-9258 | Fax:
323-888-6699 ;
800-222-3316
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>