CAL-ROYAL BTS-103 Door Bottom Sweep Installation Guide
- June 5, 2024
- CAL-ROYAL
Table of Contents
CAL-ROYAL BTS-103 Door Bottom Sweep
Door Bottom Sweep
Installation Guidelines:
- Determine the required length, mark and cut the the door bottom sweep to full width of the door.
- Close the door and place door bottom sweep along outside bottom edge of door so that it makes contact with threshold. Mark door in center of slotted holes.
- Drill pilot holes in door at marks.
- Fasten door bottom sweep to door with screws.
- Adjust to ensure firm contact with threshold / above finish floor.
Tools Required:
- Power tool drill Measuring tape
- Marker
- Caulking gun
- Screw driver
- Cutting tools (hacksaw & plier)
Packaging includes:
Screws for wood and metal doors
Fastener:
Screws Size – #6 x 5/8″ PPHSMS
HINT: “Where to install door sweep?”
Door sweeps are installed on one side of a door to keep out cold drafts. It
should be installed on the inside bottom edge of doors that swing into the
house, and on the outside bottom edge of doors that swing outwards.
Important Reminder: Aways use appropriate
Personal Protective Equipment (PPE) during installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>