CAL-ROYAL BTSR-107 Door Bottom Sweep with Rain Drip Installation Guide
- June 5, 2024
- CAL-ROYAL
Table of Contents
CAL-ROYAL BTSR-107 Door Bottom Sweep with Rain Drip Installation Guide
Door Bottom Sweep w/ Rain Drip
ITEM/FINISH:
BTSR-107
LENGTH: 36” & 48 VINYL INSERT MILL FINISH ALUMINUM ‘852),1,6+
Packaging includes
Screw for wood and metal doors
Installation Guidelines
- Determine the required length, mark and cut the the door bottom sweep to full width of the door.
- Close the door and place door bottom sweep along outside bottom edge of door so that it makes contact with threshold. Mark door in center of slotted holes.
- Drill pilot holes in door at marks.
- Fasten door bottom sweep to door with screws.
- Adjust to ensure firm contact with threshold / above finish floor.
Tools Required
- Power tool drill
- Measuring tape
- Marker
- Screw driver
- Caulking gun
- Cutting tools (hacksaw & plier)
HINT: “Where to install door sweep?”
HINT: “Where to install door sweep?” Door sweeps are installed on one side of a door to keep out cold drafts. It should be installed on the inside bottom edge of doors that swing into the house, and on the outside bottom edge of doors that swing outwards.
Important Reminder: Always use appropriate Personal Protective Equipment (PPE) during installation.
TESTING/RATINGS
Gasketing material for fire doors intended for application to UL listed steel
frames and/or classified steel covered composite type, and hollow metal type
fire doors rated up to 3hrs; wood and plastic covered composite type fire
doors rated up to 1-1/2 hrs; and wood core type fire doors rated up to 20
minutes.
43ZY
Fastener:
Screw Size – #6 Χ 5/8″ PPHSMS
CAL-ROYAL
PRODUCTS, INC. U.S.A.
6605 Flotilla Street, City of Commerce, CA 90040 U.S.A.
Website: www.cal-royal.com 1 Email: sales@cal-
royal.com Phone:
323-888-6601 ;
800-876-9258 I Fax:
323-888-6699 ;
800-222-3316
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>