CAL-ROYAL 5000E0 Rim Panic Exit Device Instruction Manual
- May 15, 2024
- CAL-ROYAL
Table of Contents
5000E0 RIM PANIC EXIT DEVICE
INSTALLATION INSTRUCTIONS
5000E0 Rim Panic Exit Device
BEFORE INSTALLING DEVICE, PLEASE CHECK:
- IF DOOR FITTED AND HUNG.
- SIZE OF EXIT DEVICE FUNCTION AND DESIGN…
2.1.36”DOORS,CAN BE CUT TO FIT DOORS DOWN TO 30” WIDE.
2.2.48”DOORS,CAN BE CUT TO FIT DOORS DOWN TO 36” WIDE.
2.3.HAND OF DEVICE AGAINST APPLICATION.
TYPE OF INSTALLATION
APPLY HARDWARE
2.1. DRILL HOLES
MARK DOOR FACE AND DRILL HOLES IN ACCORDANCE WITH THE DIAMETERS SUGGESTED .
SEE ATTACHED TEMPLATE.
CENTER OF CYLINDER END OF BODINSIDE FACE OF THE DOOR
2.2. INSTALL CYLINDER
-
INSERT THE CYLINDER THROUGH CY
RING THE HOLE ON THE DOOR -
KEEP THE TAILPIECE HORIZONTAL.
-
MOUNT LINER ON INSIDE OF DOOR A4. TAILPIECE PROJECTION OVER INSIDE OF DOOR IS SUGGESTED IN THE RANG9/32″~15/32″. IF NECESSARY ,USE A PLIER TO BEND AND CUT TO DESIRED LENGTH.
2.3. INSTALL LEVER,OR KNOB,OR PULL TRIM
APPLY RAIL ASSEMBLY
- CHECK THE SIZE OF DEVICE ,IF CUTTING LENGTH IS REQUIED.
- DETERMINE CUT OFF LENGTH “X”BY SUBTRACTING 1 3/4” FROM “Y”.MARK CUT OFF POINT ON MOUNTING RAIL.
- DEPRESS ARM INTO RAIL OPENING AND SLIDE RAIL ONTO CHASSIS .LEVER RAIL AND FASTEN CHASSIS AND MOUNTING PLATE.
APPLY COVER AND STRIKES
ATTACH COVER TO CHASSIS WITH (4)#8TRUSS HEAD MACHINE SCREW| ATTACH END CAP TO MOUNTING PLATE WITH (2)COVER SCREWS| ATTACH STRIKE TO DOOR STOP WITH (2)STRIKE SCREW AND LOCK WASHER
EDG-4106-10/23
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>