CAL-ROYAL CR2767 Commercial Saddle Threshold Instruction Manual
- June 5, 2024
- CAL-ROYAL
Table of Contents
CAL-ROYAL CR2767 Commercial Saddle Threshold
FINISH: MILL ALUMINUM and DURO
1/2” (12.7mm) COMMERCIAL SADDLE THRESHOLD
1/2”H x 7”W
12.7 mm x 177.8 mm
FASTENERS: #10 x 1-1/2”
INSTALLATION INSTRUCTIONS
- Measure width at the bottom of the frame and cut the threshold to exact full width of the opening.
- If necessary trim and notch the threshold ends to accommodate the side jamb stops.
- Mark and drill pilot holes through the pre-drilled holes in the threshold and fasten with screws provided.
- Seal both ends and along the sides of the threshold.
- Operate the door multiple times to ensure proper adjustment so as not to prevent the door from self-closing and latching.
MATERIAL FOR USE IN LISTED STEEL FRAMES AND CLASSIFIED HOLLOW METAL STEEL
COMPOSITE TYPE FIRE DOORS ARE
RATED UP TO AND INCLUDING 3 HOURS, WOOD COMPOSITE TYPE FIRE DOORS ARE RATED UP
TO AND INCLUDING 1-1/2 HOURS,
AND WOOD CORE FIRE DOORS ARE RATED 20 MINUTES WITHOUT HOSE STREAM.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>