levenhuk Star Sky P1 Astroplanetarium User Manual

: June 5, 2024
: levenhuk

Table of Contents

Star Sky P1 Astroplanetarium
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Star Sky P1 Astroplanetarium

DISCOVERY START SKY P1/P2 PLANETARIUM

User Manual

© 2022 Discovery or its subsidiaries and affiliates. Discovery and related logos are trademarks of Discovery or its subsidiaries and affiliates, used under license. All rights reserved. Discovery.com
levenhuk.com
Levenhuk Inc. (USA): 928 E 124th Ave. Ste D, Tampa, FL 33612, USA, +1 813 468-3001, contact_us@levenhuk.com
Levenhuk Optics s.r.o. (Europe): V Chotejně 700/7, 102 00 Prague 102, Czech Republic, +420 737-004-919, sales-info@levenhuk.cz
Levenhuk® is registered trademark of Levenhuk, Inc.
© 2006—2022 Levenhuk, Inc. All rights reserved.
20211222

DISCOVERY STAR SKY P1/P2 PLANETARIUM

Do not look at the light source when the device is on. This may cause PERMANENT RETINAL DAMAGE and may lead to
BLINDNESS. Children should only use the device under an adult’s supervision.
Getting started
Install the batteries in the remote control (only for Discovery Star Sky P2). Connect the power cable to the device and the DC
adapter (not included) via a USB plug and connect it to the AC power supply.
Discovery Star Sky P2 is equipped with a built-in battery and can operate autonomously. The operation time after being fully
charged is up to 6 hours in white light mode and up to 5 hours in color mode. The approximate charging time is 2 to 3 hours.
When the battery is fully charged, the indicator (4, Fig. 1) will change from red to green.
Using
Choose the right place to project an image: a plain white ceiling or wall will give the best effect. The optimal distance from
the astroplanetarium is approx. 1.5—2m. Place the device on a flat surface. Turn the lights off and close the curtains to make
the room dark.

To turn the astroplanetarium on or off, press and hold the button on the device body (1, Fig. 1), or use buttons (1) and (2) on
the remote control (Fig. 2) (only for P2). Press and hold the button on the device body (for 1.5 sec.) to change the light color.

Music box (only for P2). Press and hold the button (3, Fig. 1) to turn the music on or off. Press the button (3, Fig. 1) to
switch to the next tune (8 tunes available) or use the remote control buttons.
Rotation. To start the rotation of the astroplanetarium, press the button on the device body (2, Fig. 1) or on the remote
control (11, Fig. 2). Press and hold the button (2, Fig. 1) to turn the timer on or off.
Film set replacing. To replace the film set, follow the instructions in Fig. 3.

Specifications

|

Discovery Star Sky P1

|

Discovery Star Sky P2

---|---|---

Power supply

|

Micro USB 5V, 1A

|

built-in 3.7V, 1200maH lithium battery operating time: 5—6h,

charging time: 2—3h

Micro USB 5V, 1A

Remote control

|

—

|

(1 CR2025 battery)

Timer

|

Projection area

|

50m²/538ft.²

Care and maintenance

The device is suitable for indoor use only. The device is not waterproof. To clean the surface of the device, unplug the device. Use only a dry, soft cloth for cleaning. Strictly follow the instructions and do not disassemble or drop the device as it may result in a loss of functionality.

Battery safety instructions

Always purchase the correct size and grade of battery most suitable for the intended use. Make sure the batteries are installed correctly with regard to polarity (+ and –). Never short-circuit batteries as this may lead to high temperatures, leakage, or explosion. Never heat batteries in order to revive them. Do not disassemble batteries. Keep batteries out of the reach of children, to avoid risk of ingestion, suffocation, or poisoning. Utilize used batteries as prescribed by your country’s laws.

Warranty: 2 years. For further details, please visit our web site: www.levenhuk.com/warranty
The manufacturer reserves the right to make changes to the product range and specifications without prior notice.