nVent HOFFMAN ULTRX Door Stop Kit Instruction Manual
- June 13, 2024
- nVent HOFFMAN
Table of Contents
nVent HOFFMAN ULTRX Door Stop Kit
Product Information
- Product Model: 87568234
- Revision: B
- Language: English
- Quantity: 1
Product Usage Instructions
- Start by gathering the necessary tools and materials for installation.
- Locate the door flanges where the installation needs to be done.
- Using a drill with a .209 diameter, drill two holes through the door flanges at the specified locations shown in the diagram.
- Make sure to countersink the holes on the exterior side of the door for a flush finish.
- Repeat steps 2 to 4 for the second door flange.
- Once the holes are drilled, proceed with the installation process as per the rest of the user manual.
Please note that the above instructions are provided in English. If you require instructions in another language, please refer to the corresponding section in the user manual.
Door Stop Kit
- Locate and drill (2) .182” dia. holes through front collar tab surface. Silicon seal 8–32 screw and nut.
- Drill (2) .209” dia. holes through door flanges at locations shown. Countersink hole; exterior side.
- Assemble arm to slide and fasten to door.
- Tighten all screws to 15 in–lbs.
NOTE: Door stop can be mounted to bottom or top of enclosure.
Rev. B
© 2018 Hoffman Enclosures Inc.
PH 763 422 2211 • nVent.com/HOFFMAN
P/N 55325001 87568234
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>