ENERMAX ESC001 M.2 Heatsink Red User Manual

June 4, 2024
ENERMAX

ENERMAX ESC001 M.2 Heatsink Red

ENERMAX ESC001 M.2 Heatsink Red User
PRODUCT

INTRODUCTION

Thank you for choosing ENERMAX product. If there is any installation problem, please contact our customer service via email: enermax@enermax.com.tw.
Please note that ENERMAX cannot accept liability for damage caused by compatibility problems.

Parts ListENERMAX ESC001 M.2 Heatsink Red User
FEATURED

  1. White thick thermal pad is for single-sided M. SSD (.mm)
  2. Grey thin thermal pad is for double-sided M. SSD (.mm)

Heatsink Installation

ENERMAX ESC001 M.2 Heatsink Red User FIG
2

Take off the thermal pad film, place the thermal pad on groove of the backplate.
For single-sided M. SSD (flat back without components), please use .mm (White) thermal pad; For double-sided M. SSD (both sides with components), please use .mm (Grey) thermal pad.ENERMAX ESC001 M.2 Heatsink Red User FIG
3

insert M. SSD into the groove and chip side face out. Expose the connector and screw hole.

Place the thermal pad to the inner heatsink and remove the film.ENERMAX
ESC001 M.2 Heatsink Red User FIG 5

Insert the heatsink on one side and apply pressure to snap it into the backplate.ENERMAX ESC001 M.2 Heatsink Red User FIG 6 Install into motherboard M.2 slot, and fasten by screw.
© 2021 ENERMAX Technology Corporation. All rights reserved. Technical changes, printing errors and mistakes expected. Some trademarks may be claimed as the property of others.
This box is printed 100% recyclable paper with non-toxic vegetable oil based ink.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals