kikka boo 76-150cm i-Bronn Car Seat Instruction Manual

kikka boo 76-150cm i-Bronn Car Seat

Important Safety Instructions

The instructions for use must be kept for the entire life of the universal child restraint system.

1. This car seat provides optimal safety in all installation positions for which it was designed.

2. This is an i-Size Universal Enhanced Child Restraint System (76-150cm). It is approved pursuant to European Regulation 129 ( ECE R129 ), for use in i-Size compatible car seats as indicated by manufacturers in the car owner’s manual. If you have questions, please consult either the Enhanced Child Restraint System manufacturer or the distributor.

3. This is an i-Size booster seat Universal Enhanced Child Restraint System (100-150cm). It is approved according to ECE R129, for use in i-Size compatible seats, as indicated by the manufacturer in the car owner’s manual. If you have questions, please consult either the Enhanced Child Restraint System manufacturer or the distributer.

4. This is a seat for specific cars (76-150cm) and is an Enhanced Child Restraint System. It is approved according to European Regulation R129, for use in specific
   cars detailed in the applicable vehicle list. If you have questions, please consult either the Enhanced Child Restraint System manufacturer or the retailer.

5. This is an i-Size Enhanced Child Restraint System, approved pursuant to European ECE R129, for its general use in cars, although it is not suitable for all cars.

6. It should be installed in cars for which the manufacturer states in its car owner’s manual that the vehicle is suitable for an ‘i-Size Universal’ child restraint system for this age range.

7. The product has been approved pursuant to European regulation ECE R129 and can be used for heights between 76 and 150 cm and maximum weight 36 kg.

8. Make sure that the buckle is correctly fastened before starting to drive.

9. Any straps holding the restraint to the vehicle should be tight, that any support-leg should be in contact with the vehicle floor, that any straps or impact shields restraining the child should be adjusted to the child’s body, and that straps should not be twisted.

10. Ensure that any strap or belt that holds the child is not folded or twisted and remains tightened.

11. Ensure that the abdominal belt or strap rests as low as possible over the child’s hips, on both sides.

12. In the event of an accident, even if there are no apparent damages, the seat may be unsafe. The seat should be replaced after being subjected to the sudden and strong stresses associated with an accident.

13. Instructions illustrations are for informational purposes only. The child restraint system may contain small differences compared to the photographs or images in the instructions manual. These variations do not affect its approval by Regulation ECE R129.

14. Under no circumstances should the car seat be installed in the car’s passenger seat opposite the direction of travel if there is an active airbag.

15. Please read the instructions carefully, as incorrect installation could result in serious injury. In this case, the manufacturer shall not be held liable.

16. Ensure that all the locking devices are engaged before use.

17. It is dangerous to undertake any changes or additions to the safety seat with approval from the competent authority. It is dangerous to not strictly follow the installation instruc-tions provided by the child car set manufacturer.

18. Please never use the safety seat without its cover or without the harness protectors.

19. Make sure to protect the child safety seat from direct sunlight as it could heat up and hurt the child.

20. The car seat should remain permanently installed in the vehicle, even when the child is not in it. Never leave the child unattended when sitting in the car seat, even when the seat is outside the vehicle.

21. Make sure that any luggage or objects that could cause injuries in the event of an accident are fastened securely.

22. The cover of the child restraint system should not be replaced with another, unless recommended by the manufacturer, because it is an integral part of the system for securing children!

23. It should be installed in cars for which the manufacturer states in its car owner’s manual that the vehicle is suitable for an i-Size Universal Enhanced Child Restraint System for this age range.

24. Security is only guaranteed if the child restraint is fitted in accordance with these instructions.

25. For the i-Size Universal Enhanced Child Restraint System, the user must read the instructions manual of the vehicle’s manufacturer.

26. Do no use the car seat in rearward facing position.

27. It is important to ensure that any lap strap is worn low down, so that the pelvis is firmly engaged.

28. The instruction must be retained on the child restraint for its life period.

29. The hard components or plastic parts of safety device for children should be deployed and installed in way that during everyday use of the vehicle not be jammed by the movable seats or doors. Prevent harness/vehicle belt from getting trapped between car doors or rubbing against sharp parts of the seat or body.

30. All belts that fix the restraint system to the vehicle must be tightened , all belts retaining the child must be adjusted according to the child’s body. Twisting of the belts shall not be allowed.

31. Don’t use another support point of contact except the ones described in the instructions and marked on the child restraint system.

32. If the i-Size Universal Enhanced Child Restraint System offers alternative support point of contact and you consider that using that alternative route is not satisfactory, please contact the manufacturer of the child restraint system.

33. Install the car seat in the seating positions indicated in this instruction.

34. Do not use the car seat in the house. It is not designed for home use and should only be used in the vehicle.

35. Before you set any mobile or adjustable part of the child seat, you need to remove your child from the child seat.

36. Check regularly the belts for wearing by paying special attention to the fixing points, the safety guards and the adjusting devices.

37. Do not leave the buckle partially closed, it must be locked when all parts are engaged. You must be able to remove the child from the seat immediately in case of emergency. You have to teach the child not to play with the buckle.

38. Keep the child’s chair at a safe place away from children when not in use. Avoid placing heavy objects on the chair. Prevent contact of your vehicle chair with corrosive substances, for example acid from the battery.

39. NEVER hold a baby on your lap in a vehicle. The forces released in a collision are way too high for any person to hold on to the baby. Never secure yourself and the child with only one vehicle seat belt.

NOTICE Do NOT install in front seats except in these specific cases:

1. When the car does not have back seats.
2. When all back seats are occupied by children less than or equal to 135 cm tall.
3. When it is not possible to install all child restraints in the back seats.
   In seats with: ISOFIX anchorages and Top Tether anchor points and 3-point belt (car’s seat belt).

ATTENTION The child seat must only be used in this seat IF it has ISOFIX anchorages, top tether points a lap and 3 points belt: diagonal (A) and abdominal (B).

PARTS

1. Headrest;
2. Shoulder strap belt guide;
3. Backrest;
4. Chest pad;
5. Comfortable Cushion (Suitable for 76-87cm);
6. Shoulder strap;
7. Buckle;
8. Crotch strap;
9. Adjuster;
10. Harness adjusting strap;
11. ISOFIX insertion guides;
12. Headrest adjustable switch;
13. Top tether;
14. Pulling regulator;
15. ISOFIX top-tether connector;
16. Lap belt guide;
17. ISOFIX unlock button;
18. ISOFIX connector.

SETTING THE SHOULDER BELT HEIGHT

1. Check whether the shoulder belts are set at the right height for your child. The shoulder belts should be inserted into the belt slots that lie at shoulder height or just above.
2. Step1. Loosen the harness .Press the adjust button to release the harness with one hand, use the other hand to pull out the shoulder straps outward.
   Step2. Pull the headrest switch on upward and downward to adjust the height of the harness and the headrest according to the child’s height.

USING THE BUCKLE
Locking Method: Align the left and right buckle tongues and insert into the buckle until you hear a ‘‘click”.
Unlocking method: You can press the red button of the buckle downwards and the two metal sections will pop up.

ADJUSTING THE HARNESS

1. Loosening the shoulder harness: Press the adjustment button under the cover and at the same time pull both shoulder straps forward.
2. Tightening the harness: Pull the adjustment strap until the harness is fully tightened.

HOW TO USE THE ISOFIX CONNECTOR

In order to lock the ISOFIX connector to the anchorage points successfully, you can use ISOFIX insertion guides:

1. Locate the ISOFIX anchorage points and place the ISOFIX insertion guides over the two points.
2. Extend the ISOFIX brackets and connect them to the anchorage points of the vehicle.

FORWARD FACING INSTALLATION (76-105 CM)

1. Press the ISOFIX unlock button and push out the ISOFIX connector. Find the vehicle ISOFIX anchor, make sure the ISOFIX connector is attached to the anchor correctly, meanwhile
   push the seat until you hear a “click”.
   Notice : Check the ISOFIX unlock button if it shows green, make sure that it is installed firmly. (Green means locked correctly, red means unlocked or not locked).

2. Push the child’s backrest until attached to the vehicle backrest tightly. Adjust the length of the top tether to the most suitable position. Connect the top tether with the fixing point of the car.

3. String the belt of the top tether until the pulling regulator shows green. Release the buckle. Put the child into the safety car seat, align the left and right buckle tongues and insert into the buckle until you hear a “click”.

FORWARD FACING INSTALLATION (100-150 CM, 3-12 YEARS OLD)

1. Put away the comfortable cushion and 5-point harness.
   Notice: When used with height 100-150 cm, this seat can be installed by ISOFIX +adult safety belt or only by adult safety belt.

2. Removing 5-point harness and storage the accessory pad
   A: Open the flat on the back of the seat and stow the shoulder sections of the harness behind.
   B: To store the 5-point safety harness away it needs to be fully loosened first. Press the red release button and undo the harness. Lift the cover under the cushion and store the buckle parts in the compatment.

3. Method 1: Installation with the adult safety belt (100-150 cm)
   Put away the ISOFIX in the booster. Put the seat against the car seat.

4. Securing the child (Method 1)
   Put the child into the child car seat and follow the routine. Use the headrest adjustable switch to adjust the height of the headrest according to the child’s height. The shoulder straps should be leveled with or just above the child’s shoulders. Fasten the car seat belt and make sure it is tight enough.

5. Method 2: ISOFIX attachments+adult safety belt (100-150 cm)
   Locate the ISOFIX anchorage points and place the ISOFIX insertion guides over the two points. Extend the ISOFIX brackets and connect them to the anchorage points of the vehicle.

6. Securing the child (Method 2)
   Put the child into the child car seat and follow the routine. Use the headrest adjustable switch to adjust the height of the headrest according to the child’s height. The shoulder straps should be leveled with or just above the child’s shoulders. Fasten the car seat belt and make sure it is tight enough.

UNLOCKING THE ISOFIX

1. Press the ISOFIX unlock button to release the ISOFIX connector and take away the seat.
2. Removing the cover
   Adjust the headrest up to the heighest position, take away the comfortable cushion. Then release the buckle to remove the chest pad. Remove the headrest cover and seat cover carefully.

CARE AND MAINTENANCE

• Wash the covers and shoulder pads with clean water under 30 degrees.
• Clean the plastic parts and the buckle using a damp cloth.
• Remove the harness system before washing with soap water.
  Produced for Kikka Group Ltd., Vasil Levski 121, Plovdiv, Bulgaria. Made in China.
  Complies with EN R129.

Kika Group Ltd.
Vasil Levski 121
4000 Plovdiv, Bulgaria
[email protected]
+359 32 51 51 51

www.kikkaboo.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>