NEXIGO DLP-L01 DLP Link Active Shutter 3D Glasses User Manual
- June 17, 2024
- NEXIGO
Table of Contents
- DLP-L01 DLP Link Active Shutter 3D Glasses
- WELCOME TO THE NEXIGO FAMILY!
- CONTACT INFORMATION
- SAFETY WARNING
- GENERAL OPERATION
- MAINTENANCE
- WHAT’S IN THE BOX?
- PRODUCT INTRODUCTION
- SPECIFICATION
- OPERATION GUIDE
- FCC REQUIREMENT
- WEEE
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
DLP-Link 3D Glasses
User Manual
DLP-L01
DLP-L01 DLP Link Active Shutter 3D Glasses
User Manual
http://bit.ly/dlpl01-support-u
Register to get EXTRA ONE year warranty
@LetsNexiGo Online Support
WELCOME TO THE NEXIGO FAMILY!
Thank you for choosing the DLP-Link Active Shutter 3D Glasses! You are now
part of an exclusive club — the NexiGo family! It’s our job to make sure you
enjoy your membership. If you have any problems, please contact us any time at
cs@nexigo.com for further assistance.
This product is automatically covered by our industryleading one-year
manufacturer’s warranty.
Make sure to register your purchase at
nexigo.com/warranty within 14 days of the
delivery date, and we will extend your warranty coverage another year, for a
total of two years!
From all of us here at NexiGo, we want to thank you for your trust in us. We
look forward to serving you again in the near future.
Sincerely,
The NexiGo Team
CONTACT INFORMATION
Website: www.nexigo.com
Manufacturer: Nexight INC
E-mail: cs@nexigo.com
Tel: +1(458) 215-6088
Address: 11075 SW 11th St, Beaverton, OR, 97005, US
CAUTION
Please read these safety instructions to ensure your personal safety and
prevent property damage.
SAFETY WARNING
- NexiGo recommends that all viewers take regular breaks to avoid eye strain.
- Some people may experience physical discomfort while using this product. This discomfort may take the form of eye strain, nausea, or fatigue. If you experience any of these symptoms, please take a break. If discomfort persists, please stop using this product and consult a medical professional.
- Keep this product out of reach of unsupervised children.
GENERAL OPERATION
- This product is intended to be used for watching 3D video images on a compatible 3D Support Projector.
- Only use these 3D Glasses as intended. Do not use them for any general eyewear purposes.
- Do not use these 3D Glasses in close proximity to other devices that rely on infrared communication.
- For best results, use these 3D Glasses while in an upright position at a distance of less than 26.2 ft (8 m) from your projector.
MAINTENANCE
- To clean the 3D Glasses, wipe them gently with a soft lint-free cloth. Never clean them using strong solvents (e.g. thinners, alcohols, or benzine).
- Ensure that the 3D Glasses don’t come in contact with fire or water.
- Only charge the Glasses using the supplied USB cable.
- Do not use or store the 3D Glasses in high temperatures or direct sunlight.
- Do not drop the 3D Glasses or store them where they’re likely to fall.
- Do not attempt to modify or disassemble the 3D Glasses.
WHAT’S IN THE BOX?
DLP Link 3D Glasses x 2
Cleaning Cloth x 2
USB Cable x 2
User Manual x 1
PRODUCT INTRODUCTION
LIQUID CRYSTAL LENS
These Glasses feature high-quality LCD lenses so you can enjoy 3D content on
your projector in ultra-high resolution.
SIGNAL RECEIVER
The 3D Glasses work by receiving infrared signals from a 3D Sync Transmitter
built into your projector. Do not block or cover the signal receiver in case
of a signal interruption.
For best results, please face your projector while using the Glasses. Make
sure nothing is blocking the 3D Sync Transmitter.
POWER BUTTON
Power On: Press once.
3D Reversal: When the Glasses are powered on, tap once to switch the direction
of the 3D image sequence between left-to-right and right-to-left.
Power Off: Press and hold the power button for 3 seconds, until the LED
Indicator flashes three times and turns off.
The Glasses will power off automatically after 5 minutes without an IR signal.
LED INDICATOR
Solid Green: Glasses are powered on.
Flashes Green for 5 Minutes, then Once Every 5 Seconds:
Glasses enter standby mode.
Flashes Green Twice Every 10 Seconds: Battery is low.
Solid Red: Battery is charging.
Off: Glasses are powered off.
MICRO USB CHARGING PORT
Charge the 3D Glasses with the included cable and a DC
5V 1A wall adapter.
Please ensure that the 3D Glasses are fully charged before using them for the
first time.
Fully charge the 3D Glasses at least once every six months, even when they
haven’t been used.
SPECIFICATION
| Lens | Liquid Crystal with Active Shutter |
|---|---|
| Working Distance | 26.2ft (8 m) |
| Rate Input | 0°C–40°C |
| Working Temperature | DC 5V 1A |
| Storage Temperature | -10°C–75°C |
OPERATION GUIDE
SETUP
- Fully charge the 3D Glasses before using them for the first time.
- Display 3D content on your projector. Refer to the operation manual for your projector to enable 3D content on your device.
- Turn on your 3D Glasses by pressing the Power Button.
- Observe the 3D content at a distance of 6.5 ft to 26.2 ft (2 m to 8 m) from the projector.
- Verify that the image appears correctly in 3D. If not, please revisit the settings of your 3D projector and content streaming device.
Recommended viewing distance
FCC REQUIREMENT
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
WEEE
CORRECT DISPOSAL OF THIS PRODUCT (WASTE ELECTRICAL & ELECTRONIC EQUIPMENT)
(Applicable in countries with separate collection systems)
This marking on the product, accessories or literature indicates that the
product and its electronic accessories (e.g. charger, headset, USB cable)
should not be disposed of with other household waste at the end of their
working life. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, please separate these items from other types
of waste and recycle them responsibly to promote the sustainable reuse of
material resources.
Household users should contact either the retailer where they purchased this
product, or their local government offce, for details of where and how they
can take these items for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract. This product and its electronic
accessories should not be mixed with other commercial wastes for disposal.