TRUE FINE TD60004C 12 Inch 1 Light Traditional Pendant Instruction Manual
- May 21, 2024
- TRUE FINE
Table of Contents
TRUE FINE TD60004C 12 Inch 1 Light Traditional Pendant Instruction Manual
Overview
Assembly Instruction
1. Pass the wire through the hole in the top of Larger shade (B), screw Loop (D) to Socket (A).
2. Link Loop (D) and Mounting strap (I) by Fixture chain (E).
3. Attach the Mounting strap (I) to outlet box with Screws (H).
4. Connect the wires according to the picture above. (Please refer to the wiring instruction for details )
5. Fix Canopy (G) to Mounting strap (I) with Canopy lock ring (F).
6. Install light bulb (not included). Use one E26 base bulb.
7. Hang Smaller shade (C) to the bottom of Larger shade (B).
Wiring Instruction
1. Insert the green grounding screw into the hole with two raised dimples on the mounting bar. Wrap the ground wire from the fixture (if supplied) around the green grounding screw, then connect it to ground wire from the outlet box (if not fixed on the outlet box) using a wire connector(not supplied). If ground wire from the fixture is not supplied, wrap the ground wire (if not fixed on the outlet box) from the outlet box around the green grounding screw and tighten it.
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE POWER SUPPLY WIRES.
2. Take note of the color of the wire(s) on your fixture. Identify which group your fixture wire(s) falls into and connect the wires according to the directions below:
3. Take your fixture wire(s) from [Group A] and place evenly against the black wire from the outlet box. Do NOT twist wires together before using wire connectors.
4. Fit a wire connector over the wires and screw the connector clockwise until you feel firmness.
5. Try gently to pull the connector off the wires. If you can pull the connector off, carefully re-do steps 3 and 4 as above, and check again for a firm connection.
6. Connect the fixture wire from [Group B] to the white wire from the outlet box in the same manner. Make sure no bare wires can be seen outside wire connectors.
Product Specifications
Input voltage 120V
Rated power 60W MAX
Lamp socket E26
Cord Length 7ft.
Product Packaging
Socket × 1
Loop × 1 & Fixture chain × 1
Mounting strap × 1 & Canopy × 1
Screw × 2 & Wire nut × 3
Larger shade × 1 & Smaller shade × 1
Lamp instruction × 1
Cleaning
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
Safety Information
Always switch off the electricity supply and allow to cool for 10 minutes before changing the light bulbs.
CONTACT US
E-mail:service@24h-reply.com
Print in china
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>