levenhuk WTT10 Walkie Talkie and Binoculars Set User Manual

: June 12, 2024
: levenhuk

Table of Contents

WTT10 Walkie Talkie and Binoculars Set
Getting started
Using the walkie-talkie
Other functions
Specifications
Care & maintenance
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Walkie-talkie
User Manual

WTT10 Walkie Talkie and Binoculars Set

1. Antenna
2. TX/RX icon
3. Volume level
4. UP button
5. Monitor button
6. On/Off button
7. DOWN button
8. Earphones jack
9. Speaker
10. Microphone
11. MENU button
12. Call button| 13. Keypad locked
14. Low battery indicator
15. Talk button
16. VOX activated
17. Scanning
18. Channel/Menu item
19. CTCSS tone
20. Flashlight on/off
21. Scan button
22. Flashlight
23. Fastener
24. Pocket clip
---|---

Getting started

Press the fastener (23) and pull the pocket clip (24) gently. Open the battery compartment cover and insert 4 AAA batteries according to the correct polarity. Close the cover until it clicks. Repeat the same steps with the second device.

Using the walkie-talkie

To turn the device on, press and hold the On/Off button (6) for 3 seconds.
The volume level is controlled by the UP (4) and DOWN (7) buttons.
Both walkie-talkies must be tuned to the same channel and CTCSS tone/DCS code (if used), so that you can communicate. Press the MENU button (11) — the channel digit will start blinking. Select one of the channels using the UP (4) and DOWN (7) buttons and press the TALK button (15) to confirm the choice. To select the CTCSS tone/ DCS code for the current channel, press the MENU button (11) twice, specify the encoding type, and then one of the codes. To save the settings, press the TALK button (15).
To call the other person, press the CALL button (12). During the conversation, the transfer icon (TX) will be shown on the screen.
Press the TALK button (15) to send a voice message and keep it pressed while speaking. After the button is released, the device will give a short beep tone, indicating that the device has switched to receiving mode.
To turn the backlight on, press any button except the MENU button (11) and the monitoring button (5).
To reset to the factory settings turn the device off, press the UP button (4) and turn the device on again.

Other functions

Monitoring — is used in case of an unstable signal. It disables the squelch function so that all the signals on the selected channel become audible.
Scan — checks all channels for activity, stopping at each channel where activity is detected. Press the TALK button (15) to stop on the selected channel.
VOX — activates voice activated transmission. Using VOX and connecting a headset, you can go on the air without pressing buttons. VOX mode is switched on/off via the MENU button (11).
Keypad lock — allows you to exclude the accidental pressing of buttons. To activate this mode, press and hold the MENU button (11) for 2 seconds.
The TALK and CALL buttons will remain active!
Squelch — turns on automatically.

Specifications

Frequency range	400—470MHz
Channels	22
Radio signal radius	up to 3km /1.8mi.
Squelch	+
VOX	+
Monitoring	+
Scan function	+
Power source	4 AAA batteries (for each device)
Transmission power	0.5W
Operating temperature range	–20… +50°C / –4… +122°F

Care & maintenance

Do not use the device in potentially explosive environments or while riding a bicycle or driving a car or any other vehicle.
Consult your doctor about the safety of the device regarding any medical device you may be using.
Do not use the device near radio sources as it may cause interference.
Use a soft, damp cloth to clean the device. Do not use any ethanol- or acetone-based fluids on it.

/
STREAM WHAT YOU LOVE
ALL IN ONE PLACE
© 2022 Discovery or its subsidiaries and affiliates. Discovery and related logos are trademarks of Discovery or its subsidiaries and affiliates, used under license.
All rights reserved.
Discovery.com

levenhuk.com
Levenhuk Inc. (USA): 928 E 124th Ave. Ste D, Tampa, FL 33612,
USA, +1 813 468-3001, contact_us@levenhuk.com
Levenhuk Optics s.r.o. (Europe): V Chotejně 700/7, 102 00 Prague 102,
Czech Republic, +420 737-004-919, sales-info@levenhuk.cz
Levenhuk® is a registered trademark of Levenhuk, Inc.
© 2006—2022 Levenhuk, Inc. All rights reserved.
20211015