FIRSTECH UM-FT-1WS2-AF Keyless Entry System User Guide
- June 5, 2024
- FIRSTECH
Table of Contents
UM FT 1WS2 AF Keyless Entry System
User Guide
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate this device.
IC
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following
two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation.
This equipment complies with IC Nerve Stimulation Exposure limits set for a
general public environment and meets
RSS-102 of the IC radio frequency (RF) Exposure rules.
A separation distance of at least 3cm should be maintained from the device to
the user’s hand/foot during operation.
A separation distance of at least 10cm should be maintained from the trunk of
the body and rest in relation to the device under test.
Patent: https://firstechllc.com/patents/
QUICK START
BUTTON
FUNCTION DESCRIPTION
Tap the button 1 time to lock and/or arm your system.
Double tap the button to unlock and/or disarm your system.
Hold the button for 2.5 seconds to activate OR cancel the remote start
sequence.
1 quick TAP THEN HOLD for 5 seconds to enable or disable the proximity arming
function.
NOTE: Passive arming feature 1-08 option 4 (proximity locking) must first be activated on the system by the install tech
REMOTE FEATURES
| FEATURE | FUNCTION/DESCRIPTION |
|---|
Proximity
Lock| Once the proximity lock feature is enabled, the system will search for
the remote once the vehicle is off and all zones are closed. Once the remote
has left the proximity of the antenna the system will arm/lock. NOTE: If the
remote is within range of the antenna for 5 minutes, the proximity lock
feature will stop until a door is opened or the vehicle is started.
Proximity
Unlock| 15 seconds after the system is armed, the proximity antenna will begin
to search for the remote. When the remote moves within range of the proximity
antenna (approx. 4-6 ft) the system will disarm/unlock automatically.
NOTE: The Orange LED on the remote will flash when the remote is within range
of the proximity antenna
To reprogram your remote, cycle the key in the ignition 5 times within 7 seconds. Parking lights will flash. Then tap the Lock button on your remote. Repeat for any additional remotes. All remotes must be programmed during one sequence. If you receive two parking light flashes, your Compustar has exited remote programming mode and you must retry. Questions/comments? Contact us at 888-820-3690 from 8 AM to 5 PM PST. Also please visit www.compustar.com for ser’s manual.
| LEDs | DESCRIPTION |
|---|
Solid
| The system is locked and ready to be armed.
Blinking
| The system is armed/passive arming is on.
Solid (10sec)
| The remote battery is low. Please replace the battery in the remote.
(Activated upon the initial “Doors unlock by 1WS2R-AF and Key On” sequence)
Description of antenna module installation position
< < Antenna Module >>
< < Harness >>
< < Installation of Antenna Module >>
Note : The antenna module is mounted up in the vehicle’s dashboard.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>