FLOW FITNESS FLO26001 Heart Rate Chest Belt User Manual
- June 8, 2024
- FLOW FITNESS
Table of Contents
FLOW FITNESS FLO26001 Heart Rate Chest Belt
This chest belt monitors your heart rates during exercise and sends the heart rate signal to the receiving device or your Flow Fitness Cardio equipment
BATTERY REPLACEMENT
- STEP 1: Use a coin, open the battery cover by turning it counterclockwise to OPEN.
- STEP 2: Remove the cover and insert (replace) the battery into this device with positive (+) side facing up. (Battery type: CR2032)
- STEP 3: Place the battery cover. Use a coin to twist the cover clockwise back into place (the arrow points to CLOSE).
NOTE
- This device is for recreational use only; it is not a medical device.
- When using this device for each use, you may need to pair the heart rate sensor with your receiving device.
- Before each use, make sure that both sides of the electrode areas of the device are well moistened, and you wear it as instructed.
- Check the battery. If exhausted, please replace the battery.
- This device is water-resistant, but does not measure the heart rate in water.
HOW TO WEAR THE HEART RATE CHEST BELT
- Attach one end of the strap to the elastic belt.
- Adjust the elastic belt length to a suitable personal length and snug enough to stay in place during your workout.
- Wet both electrode areas on the back of the strap (refer to figure 3).
- Make sure the logo is in upright position and the wet electrodes are pressed firmly against your skin when you are wearing the strap.
- Tie the strap just below your chest and attach the hook to the other end of the strap.
SPECIFICATIONS
Art. code | FLO26001 | FLO26003 |
---|---|---|
Wireless tech | 5KHz | Bluetooth® |
Operating temperature | -10~50°C (14~122°F) | |
Battery | CR2032×1 pc (included) | |
Battery lifetime | approx. 800 hours |
CARE AND MAINTENANCE INSTRUCTIONS
- Keep this device in a cool and dry place when not in use and store it lying flat and avoid placement in front of the television, screen or near other sources of electromagnetic interference.
- You may wash this device under running water after every use. Never put it in the washing machine or drier and do not use alcohol or any abrasive material (steel wool or cleaning chemicals).
- Clean this device with hand gently and please check the battery cover of the strap should have been locked into place before every wash. Never bend this device sharply or twist and stretch the elastic belt for extended periods.
- Dry this device with a soft towel after every wash and air-dry away from direct heat or sunlight.
WARRANTY
We thank you for purchasing the Flow Fitness heart rate chest belt. Flow Fitness provides a two-year manufacturer’s warranty from the date of purchase. Any damage caused by misuse of users shall not be covered by the warranty.
Non-Warranty Repair Policy:
- If malfunction or damage is caused by improper use, disassembly and modification.
- If damage is caused by accident, abuse, misuse, flood, fire, earthquake, any other natural disasters or human negligence.
- Due to normal wear and tear of parts such as battery, strap,elastic belt, etc.
- If any serial number has been removed or defaced.
- The product has been used in any other way than described in this manual described.
- If it is damaged after the warranty expires.
If you want to take full advantage of the product warranty, register your Flow Fitness product at: https://www.flowfitness.com/en/register-your-product
FCC
FEDERAL COMMUNICATIONS COMMISSION STATEMENT
This device complies with FCC Rules Part 15. Operation is subject to the
following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by doing one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC CAUTION
Any changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC exposure compliance requirement, please follow operation instruction as documented in this manual.
If not disposed of properly, batteries can be harmful. Protect the environment by taking exhausted batteries to authorised disposal stations
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>