KODAK M50 Monochrome Thermal Instant Printer User Guide
- June 15, 2024
- Kodak
Table of Contents
M50 User manual (ver 3.0)
Monochrome Thermal Instant Printer
KODAK LABEL ERA
M50 M-50 M5OW M50Y
User Guide
Rating: DC 5V 1A
Bluetooth Version : V4.2 BR BLE
Operation Frequency: 2402MHz-2480MHz
Channel Numbers: 40
Channel Separation: 2MHz
Modulation Type : GFSK
Antenna Type: PCB Antenna
Antenna gain: 0.55 dBi
APP
LED
Red Green
LED
OFF Yellow Yellow
LED
OFF Yellow
60~90 MIN
– 1
– 1
– 4
– 5
ISED Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
LIMITED ONE YEAR WARRANTY ON KODAK PHOTO PRINTER AND CARTRIDGE
Product | Duration of limited warranty |
---|---|
KODAK Instant Camera and Printer | 1year |
Refill Cartridge of KODAK Instant Camera and Printer | 1year |
Limitation of warranty and liability
To the extent allowed by local law, neither Prinics nor its third-party
suppliers makes any other warranty or condition of any kind, whether express,
oral, written, statutory or implied warranties or conditions of
merchantability, satisfactory quality and fitness for a particular purpose. We
disclaim all other warranties, expressed or implied, statutory or otherwise,
including without limitation, the warranties of merchantability for a
particular purpose. Some states do not allow disclaimers of implied
warranties, so this disclaimer may not apply to you. To the extent such
warranties cannot be disclaimed under the laws of your jurisdiction. We limit
the duration and remedies of such warranties to the duration of this express
limited warranty.
Our responsibility for defective goods is limited to repair replacement or
refund as described below in this warranty statement.
Prinics Co., Ltd(“We”) may use this warranty. We extend this limited warranty
only to the consumer who originally purchased the product (“you”). It does not
extend to any subsequent owner or other transferee of the product.
This limited warranty does not cover any damage due to: (a) transportation;
(b) storage; (c) improper use; (d) failure to follow the product instructions
or to perform any preventive maintenance; (e) modifications; (f) unauthorized
repair; (g) normal wear and tear; or (h) external caused such as accidents,
abuse, or other actions or events beyond our reasonable control.
Extent of limited warranty
This Limited warranty applies to above mentioned products. We warrant that
above products specified will be free from defects in materials and
workmanship for the duration specified above, which Limited Warranty Period
begins on the date of product. If we receive during the applicable warranty
period, notice of a defect in any product which is covered by the warranty, we
shall either repair of replace the product at our option. We shall have no
obligation to repair and replace until the customer returns the defective
product to us.
To obtain warranty service, you must contact us by email at
support@kodakphotoprinter.com for supports
during the warranty period to obtain a defective merchandise authorization
(“DMA”) number. Please note that customer is responsible for shipping charges
for service request. No warranty service will be provided without a DMA number
Made in Korea
@Prinics Co., LTD.
The Kodak trademark, logo and trade dress are used under license from Kodak.
FCC (Federal Communications Commission)
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
Caution: Any changes or modifications to the equipment not expressly approved
by the party responsible for compliance could void user’s authority to operate
the equipment.
This appliance and its antenna must not be co-located or operation in
conjunction with any other antenna or transmitter.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Any questions?
In case you need any assistance, please send an email to support@kodakphotoprinter.com.
The Kodak trademark, logo and trade dress are used under license from Kodak. www.kodakphotoprinter.com
If you encounter any issues or have any questions,
our customer service team is available 24/7 right by your side.