HOOKE ROAD BXG.1013-S Wrangler TJ Stinger Bumper Installation Guide
- June 1, 2024
- HOOKE ROAD
Table of Contents
HOOKE ROAD BXG.1013-S Wrangler TJ Stinger Bumper Installation Guide
(1) Contents:
(2) Tools required:
- a. 19mm socket wrench;
- b. 5mm socket wrench;
- d. 19mm wrench;
- g.5mm Allen wrench;
(3) Installation time:
About 2 hours, 2-3 people may be needed. Installation time may differ
according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION!)
To view the electronic version (BXG.1013-S), please scan the QR code.
(4) Installation instruction:
Step 1: Begin the installation by removing the original front bumper.
Step 2: Assemble the bumper & the skid plate with the Button Head Socket Cap
Bolts Screws (M820), Split Lock Washer (D8), Flat Washer (M816*1.2), Flange
Hex Lock Nuts (M8).
Step 3: Install the bull bar into the bumper with the Button Head Socket Cap
Bolts Screws (M820), Split Lock Washer (D8), Flat Washer (M816*1.2), Flange
Hex Lock Nuts (M8).
Step 4: Insert the bumper into the car frame and place the winch plate and tighten it with the Hex Bolt (M1230), Split Lock Washer (D12), Flat Washer (M1230*2).
Step 5: Assemble the D-rings.
Step 6: The installation is complete. We hope you enjoy a wonderful off-road life with this quality product!
Attention:
- The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of question about your purchase.
Hooke Road to find your parts
