HOOKE ROAD BXG.5200-S Tundra Steel Front and Rear Step Bumper Combo Installation Guide
- June 1, 2024
- HOOKE ROAD
Table of Contents
MAKE A DIFFERENCE
Front Bumper BXG.5200-S
Contents:
| Qty | Part Name | Size(mm) | Picture |
|---|---|---|---|
| 4 | Hex Bolt | M12*110 | |
| 8 | Hex Bolt | M12*30 | |
| 8 | Hex Bolt | M8*20 | |
| 8 | Button Head Socket Cap Bolts Screws | M8*20 | |
| 12 | Split Lock Washer | D12 | |
| 16 | Split Lock Washer | D8 | |
| 24 | Flat Washer | M12302 | |
| 16 | Flat Washer | M8201.5 | |
| 12 | Hex Nuts | M12 | |
| 16 | Flange Hex Lock Nuts | M8 |
Tools required:
A. 18mm Wrench;
B. 13mm Wrench;
C. 19mm Socket Wrench;
D. 18mm Socket Wrench;
E. 14mm Socket Wrench;
F. 5mm Hex Socket Wrench;
Installation time:
About 2 hours, 2-3 people may be needed. Installation time may differ
according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION!)
To view the electronic version (BXG.5200-S), please scan the QR code.
https://drive.google.com/drive/folders/1pbVgCekSAxwjoEjaUNynjiPgRzAf_gXG?usp=share_link
Installation instruction:
Step 1: Remove the original front bumper and relative accessories.
Step 2: Assemble the left wing & the right wing & the main body with the Hex Bolts (M1230), Split Lock Washer (D12), Flat Washer (M1230*2), Hex Nuts (M12).
Step 3: Install the Bull Bar (A, B, C) into the bumper with the Hex Bolt (M820), Split Lock Washer (D8), Flat Washer (M820*1.5), Flange Hex Lock Nuts(M8).
Step 4: Install the winch bracket onto the car frame using the factory nuts.
Notes: The winch bracket is used for the installation of the winch.
Step 5: Assemble the bumper & the winch bracket with the Hex Bolt (M12110), Split Lock Washer (D12), Flat Washer (M1230*2), Hex Nuts (M12).
Notes: Tighten up the bolts on both sides after adjusting the height of the bumper. Leave a proper distance between the bumper and the car frame as the picture shown.
Step 6: Install the skid plate onto the bumper the Hex Bolt (M820), Split Lock Washer (D8), Flat Washer (M820*1.5), Flange Hex Lock Nuts(M8).
Step 7: Install the license plate bracket into the bumper with the Hex Bolt (M820), Split Lock Washer (D8), Flat Washer (M820*1.5), Flange Hex Lock Nuts(M8).
Step 8: The installation is complete. We hope you enjoy a wonderful off-road life with this quality product!
Attention:
- The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of question about your purchase.
Hooke Road to find your parts
HookeRoad4x4
Post Your Jeep/Truck
w/Hashtag #hookeroad to Win Discount Every Week