HOOKE ROAD BXG.3065 Climber Full Width Front Bumper Installation Guide
- June 1, 2024
- HOOKE ROAD
Table of Contents
HOOKE ROAD BXG.3065 Climber Full Width Front Bumper
Specifications:
- Product Name: Front Bumper
- Model: BXG.3065
Parts Included:
- 4 Button Head Socket Cap Bolts Screw M6*16
- 4 Button Head Socket Cap Bolts Screw M6*12
- 4 Split Lock Washer
- 2 Split Lock Washer
- 4 Flat Washer
- 6 Flat Washer
- 2 Nylon Round Spacer
- 4 Hex Nut
- 4 Nylon Insert Lock Nut
Tools Required
- 4mm L-Wrench
- 10mm, 19mm Wrench
Front Bumper
Contents:
Tools required
- 4mm L-Wrench;
- 10mm, 19mm Wrench
Installation time
About 1 hour, 1-2 people may be needed. Installation time may differ according
to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION!)
To view the electronic version (BXG.3065), please scan the QR code.
Installation instruction:
-
Step 1: Remove the factory front bumper, ready to install our product.
-
Step 2: First, attach the light bar brackets to the main body using M6*16 button head socket cap bolts screws. This step isn’t 100% necessary. Depends if you install the lamp.
-
Step 3: Assemble the license plate bracket (A1, A2) with the M616 button head socket cap bolts screws. And then install it into the bumper with the M616 button head socket cap bolts screws.
-
Step 4: Lift the bumper, align it with the holes, and tighten the screws on the bar using M12 nuts.
-
Step 5:
The installation is complete. We hope you enjoy a wonderful off-road life with this quality Hooke Road product!
Attention
- The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of question about your purchase.
