HOOKE ROAD BXG.3066 JL Climber Rear Bumper With License Plate Mount Installation Guide
- June 1, 2024
- HOOKE ROAD
Table of Contents
HOOKE ROAD BXG.3066 JL Climber Rear Bumper With License Plate Mount
Installation Guide
Contents
Rear Bumper
D-ring Mount
License Plate Bracket
| Qty | Part Name | Size(mm | Size(mm) |
|---|---|---|---|
| 6 | Hex Head Flange Bolts | M14*40 | |
| 2 | Hex Bolt | M8*20 | |
| 2 | Split Lock Washer | D8 | |
| 2 | Flat Washer | M8161 | 
2| Flange Hex Lock Nuts| M8|
8| Button Head Socket Cap Bolts Screws| M4*16|
1| L-Wrench| M4|
4| Sensor Brackets| |
8| Cable Ties| |
1| D-rings| |
Tools required
- a. Drive Socket Ratchet Wrench；
- b. 5mm Hex Bit Socket;
- c. 21mm Shallow Socket;
Installation time
About 1 hour, 1-2 people may be needed. Installation time may differ according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT ANDREADINSTRUCTIONSCAREFULLY BEFORE STARTING INSTALLATION!)
To view the electronic version (BXG.3066), please scantheQRcode.
Installation instruction
Step 1: Before installing our product, ensure that the vehicles parked in safe
and level location, and remove the original car rear bumper.
Step 2 : First, remove the lights from our bumper. Insert the plug of the
original car radar harness into the corresponding radar socket, secure the
radar to the rear bumper using the sensor bracket, and fasten it with M4*16
screws to prevent shaking or damage during driving.
Step 3: Next, install the D-ring mount onto the factory vehicle mounting
beam using M14*40 hex head flange bolts. Tighten the screws securely.
Step 4: Next, install the license plate bracket onto our bumper. Use
M8*20 screws for assembly and tighten them securely.
- (2) M8*20 Hex Bolts
- (2) D8 Split Lock Washer
- (2) M8161 Flat Washer
- (2) M8 Flange Lock Hex Nuts
Step 5: It is recommended to install the bumper with assistance. Lift the
bumper, align it with the original vehicle mounting holes, and secure it using
M14*40 hex head flange bolts. Adjust the gap from the vehicle and tighten the
screws.
Step 6: Install the D-rings into the bumper.
Step 7: The installation is complete. We hope you enjoy a wonderful off- road life with this quality Hooke Road product.
Attention
- The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of question about your purchase.
Google Hooke Road to find your parts.
Feel Free To Share Your Vehicle @HookeRoad4x4
With The Hashtag #hookeroad If You’d Like
