i Board IB-P094C Black Running Boards Style Installation Guide
- June 1, 2024
- i Board
Table of Contents
iBoard® by APS
PART#: IB-P094C&J
IB-P094C Black Running Boards Style
Scan for Installation Video
https://www.iboardauto.com/iboard-videos/
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. REMOVE CONTENTS FROM
BOX AND VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS RECOMMENDED.
ROCKER PANEL MOUNT
NO DRILLING REQUIRED
Fastener Size | Tightening Torque (ft-lbs) | Required |
---|---|---|
6mm | 6-7 | X |
8mm | 16-18 | √ |
10mm | 31-32 | X |
12mm | 56-58 | X |
14mm | 92-94 | X |
PART LIST
Hardware Package A (For Bracket Installation)
Item| QTY| Description| Item| QTY| Description
1#| 6| Mounting Brackets| 2#| 12| M8 Hex Flange
Nuts
2 #
Hardware Package B (For Step Bar Installation)
Item| QTY| Description| Item| QTY| Description
1#| 12| M8X1.25-35mm Carriage Bolts| 3#| 12| M8
Nylon Lock Nuts
2#| 12| M8 Large Flat Washers| 4#| 6| Sliders
(Packed with Mounting Brackets)
STEP 1
Start installation on the driver side of the vehicle. Locate the driver side
front bracket mounting location. Select (1) Mounting Bracket, install with (2)
M8 Hex Flange Nuts. Do not fully tighten hardware at this time.
STEP 2
Move to the Driver Side Center & Rear Mounting location. Repeat Step 1 to
install the Driver Side Center & Rear Mounting Bracket .
Note: All (6) Mounting Brackets are universal.
STEP 3
Once all (3) Driver side mounting brackets are installed, then proceed to
the Step Bar installation. (Figs 2 & 3)
(1) Select (1) Slider and (2) M8X1.25-35mm Carriage Bolts;
(2) Install (2) M8X1.25-35mm Carriage Bolts in (1) Slider.
(3) Slide the Slider (with carriage bolts) to the Step Bar.
(4) Repeat to install the other (2) sliders to the step bar.
(5) Attach the Step Bar (with the Sliders) onto the installed mounting
brackets. Position the Sliders to the installed brackets.
Secure the Step Bar to the installed Brackets by using (6) M8 Large Flat
Washers and (6) M8 Nylon Lock Nuts and (3) Sliders, (Fig 3). Do not fully
tighten hardware at this time.
Note: The Sliders are packed with the Mounting Brackets.
Level and adjust the Step Bar and fully tighten all hardware.
Repeat Steps 1-3 for the other side Step Bar installation. The installation is
completed!!!
Attention
Do periodic inspections to the installation to make sure that all hardware is
secure and tight.
In order to protect your bars/boards, please use mild soap/non-abrasive
products for cleaning only.
Customer Support:info@iboardauto.com
Rev. 20231001
Documents / Resources
| i
Board IB-P094C Black Running Boards
Style
[pdf] Installation Guide
IB-P094C Black Running Boards Style, IB-P094C, Black Running Boards Style,
Running Boards Style, Boards Style, Style
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>