HOOKE ROAD BXG.9912-S Mid Size Truck Roll Bar Extension Kit Instruction Manual
- June 1, 2024
- HOOKE ROAD
Table of Contents
HOOKE ROAD BXG.9912-S Mid Size Truck Roll Bar Extension Kit
Contents
-
Extension Parts
-
Decorative Plates (1)
-
Decorative Plates (2)
-
Mount Brackets
-
Iron Plates
Parts
| Qty | Part Name | Size(mm) | Picture |
|---|---|---|---|
| 4 | Button Head Socket Cap Bolts Screws | N8*25 | |
| 2 | Button Head Socket Cap Bolts Screws | M8*20 | |
| 26 | Button Head Socket Cap Bolts Screws | M4*10 | |
| 6 | Split Lock Washer | D8 | |
| 6 | Flat Washer | M8202 |
Tools Required
a. Drive Socket Ratchet Wrench;
b. 5mm Hex Bit Socket;
c. 13mm Wrench;
d. 13mm Shallow Socket;
Installation Time
About 40 minutes, 1-2 people may be needed. Installation time may differ
according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION!)
To view the electronic version (BXG.9912-S), please scan the QR code.
Installation Instruction
Step 1: Firstly, this product requires the purchase of our roll bar for
installation.
Before installing, the side parts (red area) of the roll bar need to be
removed.
Step 2: Next, assemble the extension accessory onto the roll bar, using
the screws that were used for the roll bar installation.
4 M820 Button Head Socket Cap Bolts Screws
4 M820*2 Flat Washer
2 M8 Flange Hex Lock Nuts
Step 3: Next, use M8*20 screws to install the mount brackets on both the
left and right sides. You can choose any hole position for installation, then
tighten all the screws.
Step 4: Next, the method of securing the brackets is divided into with or without rails. Please install according to the configuration of your vehicle.
-
Without Rails: Place the iron plate behind the bracket, then press the upper part against the vehicle body, and secure it with an M8*25 screw. Install only one screw for each iron plate.
-
With Rails : Place the iron plate into the rail, align it with the bracket holes, and use your hand to support the edge of the iron plate. Then, install M8*25 screws.
Step 5: Finally, use M4*10 screws to attach the decorative plates (1) &
(2) on both sides.
Step 6: The installation is complete. We hope you enjoy a wonderful off-
road life with this quality Hooke Road product!
Attention
- The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of question about your purchase.
Hooke Road to find your parts.
CUSTOMER SUPPORT
Feel Free To Share Your Vehicle @HookeRoad4x4
With The Hashtag #hookeroad If You” d like
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>