HOOKE ROAD F150 Guardian Front Bumper Installation Guide
- June 1, 2024
- HOOKE ROAD
Table of Contents
HOOKE ROAD F150 Guardian Front Bumper
Contents
-
Left Wing
-
Main Body
-
Right Wing
-
License Plate Bracket
Parts
| Qty | Part Name | Size(mm) | Picture |
|---|---|---|---|
| 6 | Hex Bolts | M12*35 | |
| 6 | Hex Bolts | M12*30 | |
| 4 | Button Head Socket Cap Bolts Screws | M6*20 | |
| 12 | Split Lock Washer | D12 | |
| 18 | Flat Washer | M12302 | |
| 4 | Flat Washer | M6121 | |
| 2 | Nylon Round Spacer | M6121.3 | |
| 12 | Hex Nuts | M12 | |
| 4 | Nylon Insert Lock Nut | M6 | |
| 2 | Internal Tooth Star Lock Washers | M12 |
Tools required
a. Drive Socket Ratchet Wrench;
b. 4mm Hex Bit Socket;
c. 10mm, 19mm Wrench;
d. 19mm Shallow Socket;
Installation time
About 1.5 hours, 2-3 people may be needed. Installation time may differ
according to your mechanical skill level.
(PLEASE VERIFY ALL PARTS ARE PRESENT AND READ INSTRUCTIONS CAREFULLY BEFORE
STARTING INSTALLATION!)
To view the electronic version (BXG.8257), please scan the QR code.
Installation instruction
Step 1: Remove the factory front bumper, ready to install our product.
Step 2: First, in the initial step, connect the wings to the main body using M12*30 hex bolts. Repeat the same procedure on the other side.
(3) M1230 Hex Bolts
(3) D12 Split Lock Washer
(3) M 1230*2 Flat Washer
(3) M 12 Hex Nuts
Step 3: If you need to install the license plate bracket, first you need
to use M620 button head socket cap bolts and nuts to assemble the license
plate bracket. Then, use M620 screws to secure it into the main body, as
shown in the diagram.
(2) M62 0 Button Head Socket Cap Bolts Screws
(2) M6 12 1 Flat Washer
(2) M6 12* 1.3 Nylon Round Spacer
(2) M6 Nylon Insert Lock Nuts
(2) M620 Button Head Socket Cap Bolts Screws
(2) M6 12* 1 Flat Washer
(2) M6 Nylon Insert Lock Nuts
Step 4: Before installing the bumper, use internal tooth star lock
washers to secure the M12 bolts to the center installation position on the
bar. Repeat the same procedure on the other side.
Step 5: Lift the bumper, align it with the holes, and secure the bumper
to the vehicle by using M12 bolts and nuts.
Step 6: The installation is complete. We hope you enjoy a wonderful off-
road life with this quality Hooke Road product!
Attention
- The product parts in this instruction may differ slightly from the actual product contents but generally does not affect the installation of the product.
- Please feel free to contact your distributor if you have any kind of question about your purchase.
Hooke Road to find your parts.
CUSTOMER SUPPORT
Feel Free To Share Your Vehicle @HookeRoad4x4
With The Hashtag #hookeroad If You’d Like
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>