VIXEN GO VGW0223-25 Hidden Flat Wire 2 Conductor 23 Gauge Paintable Cable User Manual
- June 1, 2024
- VIXEN GO
Table of Contents
VGW0223-25
USER MANUAL
VGW0223-25 Hidden Flat Wire 2 Conductor 23 Gauge Paintable Cable
BEFORE BEGINNING YOUR INSTALLATION
Read through the entire instruction guide before getting started with the
installation.
CONTENTS
- 23AWG 2-Conductor Ultra Flat Cable (25 FT)
Only use this flat cable in low voltage electrical connections such as with LED lighting, doorbells, security cameras and speakers. Never exceed the maximum voltage rating value of 36V.
SAFETY INSTRUCTIONS
- Use safety precautions while working with scissors or sharp knives.
- Make sure to first finish all connections on the flat cable, quick connectors, etc. before connecting the line to the device or power line.
- Although this product may work well in places such as a porch or patio we recommend its use indoor only.
INSTALLATION
- Ensure full access to the location where you are planning to install the flat cable, make sure there are no furniture or other objects that will obstruct the installation area.
- Starting with one end of the strip, remove the adhesive paper (bottom layer) and start applying the flat wire to the surface where it is going to be installed. Images 1 and 2
- Once you have the strip installed you can proceed to install the terminals. Two quick connector adapters are needed, one for each end (not supplied, P/N: VGW2320).
- Open the quick connector adapter door that is on the opposite side of the preinstalled wire terminals and place the flat cable centered on top of the two contacts. The flat cable will go inside the adapter about 5/8″. Before closing the door make sure that the teeth on the adapter are making contact with the flat cable’s conductors. Images 3 and 4
- With slight force, close the door until the side retention tab clicks. Image 5
- You may choose to secure it to the installation surface using double-sided tape (not supplied). Image 6
- Repeat above steps on the other end of the strip.
- You can proceed to prime or paint the flat wire for maximum concealment. Image 7
- A 90 degree quick connector adapter (not supplied, P/N: VGW2390) can be used to change the strip’s trajectory or as a union. If using one, follow the installation procedure described above for P/N: VGW2320, the only difference is that now you must insert two flat cables on the quick connector adapter, one on each end.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>