ZMZS 1039 TrickGatorRemote Control User Manual
- June 6, 2024
- ZMZS
Table of Contents
TrickGator™ Remote Control
Alligator User’s Manual
BATTERY INSTRUCTIONS:
REQUIRES 3 X 1.5V AA & 2 X 1.5V AAA BATTERIES (NOT INCLUDED)
-
Locate and open the battery compartment cover under the Gator Boat.
-
Insert 3 X 1.5V AA batteries with polarities matching battery compartment markings.
-
Close battery cover and secure screws.
-
Reminder: sealing strip MUST be in place to prevent water leaking.
-
Locate and open the battery compartment cover behind the Controller.
-
Insert 2 X 1.5V AAA batteries with polarities matching battery compartment markings.
-
Close battery cover and secure screws.
-
Reminder: sealing strip MUST be in place to prevent water leaking.
CARE INSTRUCTIONS:
- Wipe clean, remove batteries, and store when not in use.
- Always keep hands away from propellers.
- Check and drain excess water for best performance.
- Unplug the WATER STOPPER.
- Drain water by gently shaking Gator Boat rear pointing down.
- Plug the WATER STOPPER back in place.
BATTERY WARNING:
- Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
- Do not mix old and new batteries together.
- Do not dispose of batteries for fire. Leakage, explosion, and/or personal injury may occur.
- Dispose of batteries properly.
- Always remove the batteries from the battery box when not in use for extended periods.
- Only an adult should charge rechargeable batteries.
- Only use batteries of the same or equivalent type as recommended.
- Only insert batteries with the correct polarity.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Model: #1039
Please retain this manual for future reference.
Color and contents may vary.
MADE IN CHINA
Consumer Information
1-951-371-5564
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>