VIXEN GO VGW0223-100K Gauge Paintable Cable for LED Lighting User Manual
- June 1, 2024
- VIXEN GO
Table of Contents
VIXEN GO VGW0223-100K Gauge Paintable Cable for LED Lighting
Specifications
- 23AWG 2-Conductor Ultra Flat Cable (100 FT)
- 2-Conductor Quick Connector Adapter x 4
- 2-Conductor 90 Degree Quick Connector Adapter x 2
- Maximum Voltage Rating: 36V
- Intended Use: Low voltage electrical connections such as LED
lighting, doorbells, security cameras, and speakers
Before Installation:
Read through the entire instruction guide before starting the installation.
Safety Instructions
- Use safety precautions with sharp tools like scissors or knives.
- Complete all connections on the flat cable and connectors before connecting to the device or power line.
- Recommended for indoor use only.
Installation
- Ensure full access to the installation location.
- Start at one end of the strip, remove the adhesive paper, and apply the flat wire to the surface.
- Install the terminals using the quick connector adapters.
- Secure the flat cable to the surface using double-sided tape if desired.
- Repeat the above steps for the other end of the strip.
- Prime or paint the flat wire for concealment if needed.
- Use the 90-degree quick connector adapters if changing trajectory or creating a union.
FAQ
Q: Can this flat cable be used outdoors?
A: Although it may work in outdoor locations like a porch or patio, it is
recommended for indoor use only.
BEFORE BEGINNING YOUR INSTALLATION
Read through the entire instruction guide before getting started with the installation.
CONTENTS
- 23AWG 2-Conductor Ultra Flat Cable (100 FT)
- 2-Conductor Quick Connector Adapter x 4
- 2-Conductor 90 Degree Quick Connector Adapter x 2
Only use this flat cable in low voltage electrical connections such as with LED lighting, doorbells, security cameras and speakers. Never exceed the maximum voltage rating value of 36V.
SAFETY INSTRUCTIONS
- Use safety precautions while working with scissors or sharp knives.
- Make sure to first finish all connections on the flat cable, quick connectors, etc. before connecting the line to the device or power line.
- Although this product may work well in places such as a porch or patio we recommend its use indoor only.
INSTALLATION
- Ensure full access to the location where you are planning to install the flat cable, make sure there are no furniture or other objects that will obstruct the installation area.
- Starting with one end of the strip, remove the adhesive paper (bottom layer) and start applying the flat wire to the surface where it is going to be installed. Images 1 and 2
- Once you have the strip installed you can proceed to install the terminals. Two quick connector adapters are needed, one for each end. Two extra adapters are included in this kit for multiple projects.
- Open the quick connector adapter door that is on the opposite side of the pre-installed wire terminals and place the flat cable centered on top of the two contacts. The flat cable will go inside the adapter about 5/8″.
- Before closing the door make sure that the teeth on the adapter are making contact with]the flat cable’s conductors. Images 3 and 4
- With slight force, close the door until the side]retention tab clicks. Image 5
- You may choose to secure it to the] installation surface using double-sided tape (not supplied). Image 6
- Repeat above steps on the other end of the strip.
- You can proceed to prime or paint the flat wire for maximum concealment. Image 7
- The included 90 degree quick connector adapters can be used to change the strip’s trajectory or as a union. If using them, follow the installation procedure described above for the terminals, the only difference is that now you must insert two flat cables on the quick connector adapter, one on each end.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>