VIXEN GO VGW0223-25K Hidden Flat Wire 2 Conductor 23 Gauge Paintable Cable User Manual

Table of Contents

Cable

Specifications:

Model: VGW0223-25K
Contents:
- 23AWG 2-Conductor Ultra Flat Cable (25 FT)
- 2-Conductor Quick Connector Adapter x 2
- 2-Conductor 90 Degree Quick Connector Adapter x 1
Maximum Voltage Rating: 36V
Intended Use: Low voltage electrical connections for LED lighting, doorbells, security cameras, and speakers

Before Beginning Installation:
Read through the entire instruction guide before starting the installation.

Safety Instructions:

Installation:

Ensure access to the installation location is clear.
Start by removing the adhesive paper from one end of the strip and apply it to the surface.
Install the terminals using the quick connector adapters.
Secure the strip with double-sided tape if desired.
Repeat steps for the other end of the strip.
Prime or paint the flat wire for concealment if needed.
Use the 90-degree quick connector adapter for changing trajectory or union.

FAQ

Q: Can this flat cable be used outdoors?
A: Although it may work on a porch or patio, we recommend indoor use only.

Q: What is the maximum voltage rating for this cable?
A: The maximum voltage rating is 36V. Do not exceed this value.

BEFORE BEGINNING YOUR INSTALLATION
Read through the entire instruction guide before getting started with the installation.

Use safety precautions while working with scissors or sharp knives.
Make sure to first finish all connections on the flat cable, quick connectors, etc. before connecting the line to the device or power line.
Although this product may work well in places such as a porch or patio we recommend its use indoor only.

VIXEN-GO-VGW0223-25K-Hidden-Flat-Wire-2-Conductor-23-Gauge-Paintable-
Cable-1

Ensure full access to the location where you are planning to install the flat cable, make sure there are no furniture or other objects that will obstruct the installation area.
Starting with one end of the strip, remove the adhesive paper (bottom layer) and start applying the flat wire to the surface where it is going to be installed. Images 1 and 2
Once you have the strip installed you can proceed to install the terminals. Two quick connector adapters are needed, one for each end.
Open the quick connector adapter door that is on the opposite side of the pre-installed wire terminals and place the flat cable centered on top of the two contacts. The flat cable will go inside the adapter about 5/8″. Before closing the door make sure that the teeth on the adapter are making contact with the flat cable’s conductors. Images 3 and 4
With slight force, close the door until the side retention tab clicks. Image 5
You may choose to secure it to the installation
surface using double-sided tape (not supplied). Image 6
Repeat above steps on the other end of the strip.
You can proceed to prime or paint the flat wire for maximum concealment. Image 7
The included 90 degree quick connector adapter can be used to change the strip’s trajectory or as a union. If using one, follow the installation procedure described above for the terminals, the only difference is that now you must insert two flat cables on the quick connector adapter, one on each end.