Roinvou 2+64G Android Car Play Stereo Instruction Manual
- June 1, 2024
- Roinvou
Table of Contents
Roinvou 2+64G Android Car Play Stereo
Specifications:
- Product: Central Control for Toyota PRIUS 2012 (Model: C7204)
- Tools Required for Disassembly: Wire, Mounting bracket, Installation tools
- Compliance: FCC Part 15
Product Usage Instructions
Disassembly:
- Use a pry bar to open the base of the gear shift lever and the center console decorative trim.
- Open the outer frame of the radio, disconnect connecting wires, pry open the ignition key panel, and unscrew the four screws on both sides of the radio.
- Remove the car radio by unplugging wires connected to the original vehicle.
Installation:
Note: Ensure the car’s power is cut off during installation.
- Secure the new radio onto the car frame using the mounting bracket and connect wires from the radio to the original vehicle’s wires. Reattach the radio to the center console and tighten screws on both sides.
- Reinstall the ignition key panel and center console decorative trim. Place back the base of the gear shift lever to complete installation.
Frequently Asked Questions (FAQ):
-
Q: What tools are required for disassembly?
A: Wire, Mounting bracket, Installation tools are required for disassembly. -
Q: What should I do if the wiring harness does not match during installation?
A: Contact customer service to request the correct wiring harness for installation. -
Q: What if I encounter problems during installation?
A: If you encounter any issues during installation, contact us at cheyang728@gmail.com for assistance. We aim to respond within 24 hours and provide solutions until you are satisfied. -
Q: What FCC compliance does this product have?
A: This product complies with FCC Part 15 regulations. It must not cause harmful interference and must accept any received interference.
TOOLS REQUIRED FOR DISASSEMBLY
- Wire
- Mounting bracket
- Installation tools
Disassembly
- Use a pry bar to pry open the base of the gear shift lever, then pry open the center console decorative trim and remove it.
- Pry open the outer frame of the radio, disconnect the connecting wires, then pry open the ignition key panel, and then unscrew the four screws on both sides of the radio.
- Take out the car radio, unplug the wires connected to the original vehicle, and remove the radio.
PROPOSE
Before starting the replacement job, you should prepare tools such as a
plastic pry tool and a screwdriver, and make sure the car’s power is cut off
during the installation.
Installation (If the wiring harness does not match, please contact
customer service to request the correct wiring harness)
- Secure the new radio onto the car frame using the mounting bracket, tighten the screws on both sides, then connect the wires from the radio to the original vehicle’s wires. Reattach the radio to the center console, tighten the four screws on both sides, and reinstall the ignition key panel.
- Reinstall the center console decorative trim around the radio, then put back the base of the gear shift lever. The installation of the new radio is complete.
COMPARISON
Effect of Installation
GENTLE REMINDERS
Due to the complexity of the product structure, you may encounter some
problems during installation. If you still have any questions about the
installation after reading this manual, you can contact usand we will respond
to you within 24 hours. Don’t worry; we will do our best to solve the problem
for you until you are satisfied.
After-sales email:cheyang728@gmail.com
WARN FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation