MINKA LAVERY 1451-695 Modern Wall Sconce Lighting Installation Guide

MINKA LAVERY 1451-695 Modern Wall Sconce Lighting

Product Information

Specifications

• Item Number: 1451-695
• Manufacture Date: 2024/02/19
• Mounting Plate Size: A-021-127190
• Mounting Screw Size: #8-32N*L0.5

Product Usage Instructions

Installation Instructions

1. Shut off power at the fuse box or circuit breaker.
2. Remove the old fixture and its mounting hardware.
3. Unpack the new fixture carefully and lay out all parts in a clean area.
4. Remove screws (C) on mounting plate (A) from fixture’s body (D).
5. Attach the mounting plate (A) to the junction box using mounting screws (B).
6. Ensure that the side of the mounting plate marked GND faces out.

Connecting the Wires

1. Connect the electrical wires as shown in Fig. 2.

Your installation is now complete. Return power to the outlet box and test the fixture.

FAQ

1. Q: What should I do if the fixture does not work after installation?
   A: Check the wiring connections to ensure they are properly connected. If the issue persists, consult a professional electrician.

2. Q: Can I use a different size of mounting screws?
   A: It is recommended to use the specified size (#8-32N*L0.5) for secure installation.

WA R N I N G ! S H U T P O WE R O F F AT F U S E O R C I R C U I T B R E A K E R .

MOUNTING THE FIXTURE (Fig.1)

1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.

3. Remove screws (C) on mounting plate (A) from fixture’s body (D).

4. Attach mounting plate (A) using mounting screws (B) (Size: #8-32N*L0.5”) to junction box (not included). The side of the mounting plate (A) marked “GND” must face out.
   CONNECTING THE WIRES (Fig. 2)

5. Connect the electrical wires as shown in Fig.2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to mounting plate (A) using green screw provided.

6. Tuck wire connectors neatly inside the junction box.
   FINISHING THE INSTALLATION (Fig.1)

7. Place fixture body (D) over mounting plate (A), and secure with screws (C).

8. Install (1) one candelabra base bulb (E) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)

Your installation is now complete. Return power to the outlet box and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>