MINKA LAVERY 5283-788 10 Inch W 3-Light Ashen Gold LED Incandescent Wall Sconce Installation Guide

MINKA LAVERY 5283-788 10 Inch W 3-Light Ashen Gold LED Incandescent Wall

Sconce

Product Information

Specifications:

• Item Number: 5283-788
• Maximum Wattage: Refer to product label
• Includes: Mounting Plate, Ground Screw, Mounting Screws (2)

Product Usage Instructions

Preparation:

1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in a well-lit area.

Installation:

1. Identify the Mounting Plate, Ground Screw, and Mounting Screws.
2. Secure the Mounting Plate to the desired location using the provided Mounting Screws.
3. Connect the Ground Screw to the grounding wire in your electrical box.
4. Attach the fixture to the Mounting Plate following the manufacturer’s instructions.

Power On:

After installation, ensure that all connections are secure. Turn the power ON at the fuse box or circuit breaker box. Test the fixture to verify proper functionality.
Note: The illustration in the manual is for installation reference and may not match the actual fixture purchased.

FAQ (Frequently Asked Questions)

• Q: What is the maximum wattage rating for this fixture?
  A: Please refer to the product label for the specific maximum wattage rating.

READ AND SAVE THESE INSTRUCTIONS
Item# 5283-788

PREPARATION

1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
   MOUNTING THE FIXTURE

3. To begin, it will be necessary to remove mounting plate (A) from the back plate (C) by removing screws (D) located on the side of the back plate (C). see fig. 1.

4. To begin the installation, first attach a mounting plate (A) to the junction box (JB) “not provided” by using 8-32 screws (B). Make sure threaded holes are on the top and bottom when installing the mounting plate Adjust the plate and tighten the screws to secure the mounting plate.
   The side of mounting plate (A) with “GND” marked on it and two convex points must face out.
   CONNECTING THE WIRES (Fig. 2)

5. Connect the electrical wire as shown in Fig. 2, making sure that all the wire connectors are secured. If your junction box has a ground wire (green, or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using green screw provided.

6. Tuck wire connections neatly into the junction box (JB).
   FINISHING THE FIXTURE

7. To mount the fixture to the wall. Slip back plate (C) over mounting plate (A) and align holes at top and bottom of backplate (C) with threaded holes on top and bottom of mounting plate (A).

8. Thread in screws (D) removed earlier to secure back plate (C) to mounting plate (A).

9. To begin installing the accessories, take the crystal bobeche (cb) and slip down over the candle sleeve (cs). Repeat the process until all crystals are fully installed.

10. Install 3x E12 base light bulbs (LB) up to 60 watts each or CFL or LED equivalent (not included) by the fixture specification.

DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
Your installation is now complete. You can now turn the power ON and test the fixture.

Note : The illustration (Fig. 1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>