SLV 1007680 Inground Fitting Instruction Manual
- June 1, 2024
- SLV
Table of Contents
INSTRUCTION MANUAL PART A
Inground Fitting
1007680
1007681
IP65 / IP67 ta: -20°C …+45°C
1007680
| 220V – 240V ~50/60Hz| 4W| 350 lm| 3000K| CRI >80|
Ø 10,5 x 11,5 cm| 0,60 kg
---|---|---|---|---|---|---|---
1007681|
9,5 x 9,5 x 11,5 cm
The installation requires expert knowledge and may be carried out only by an approved electrician under consideration of local and national regulations!
The light source is only exchangeable by a professional. The separate control unit is only exchangeable by a professional.
Technical Details are subject to change.
SLV UK
Unit E Chiltern Park
Boscombe Road, Bedfordshire
LU5 4LT
Operating Manual PART B
Inground Fitting
1007680 …81
Read manual carefully and keep for further use!
Safety advices for installation and operation.
Disregard may lead to danger of life, burning or fire!
Any works on the electrical connection only by electrician.
Do not alter or modify the product.
Do not fasten anything on the product.
Do not cover the product.
Operate only with intact protection glass.
If the external flexible cable or cord of this luminaire is damaged, it shall
be exclusively replaced by the manufacturer or a qualified electrician to
avoid hazard.
Take out of service when suspecting a defect or malfunction and contact your
dealer or a qualified electrician.
Take measures that children get not harmed by the product.
Do not stare into the active light source.
Additional safety advices =
Use as directed
Safety class I (1) – Connection with protective conductor.
Operate only firmly fixed on an even surface.
Operate only on normal or not inflammable surfaces.
Do not strain mechanically or expose to strong dirt contamination.
IP65: Protection against dust (dust-tight) – Protection against jetted water
from all directions.
IP67: Protection against dust (dust-tight) – Protection against the
penetration of water when temporarily submerged.
Admissible ambient temperature(ta): -20°C …+45°C.
Light Source
The light source of this luminaire may only be replaced by the manufacturer,
an authorized service technician or a comparable qualified person.
This product contains a light source of the energy efficiency class D.
Care / Storage
Disconnect product from mains and let it cool down.
Clean external surfaces regularly with a slightly moistened (water) cloth.
Remove foliage, dirt, etc. regularly from the luminaire.
The following influences may have unwanted effects on the product: acidic
surrounding, high salt content in the air, cleaning agents, fertilizer,
thawing salt, chemicals.
Store dry and clean.
Installation
Switch off mains / fixed connection cable!
Use only described accessories.
Only suited for recessed ground installation.
Follow local regulations for outdoor installations.
Do not seal the product yourself (e.g. with silicone).
Install according to declared IP type.
Install only when the weather is dry.
Provide a drainage with a minimum depth of 20 cm at the installation place.
The external flexible cable of the luminaire may not come into direct contact
with soil.
Install as shown in the figure.
Direct the underground cable with sufficient length through the cable gland.
Secure cable gland applying a suitable tool.
Electrical connection
Equip flexible wire ends with suitable wire ferrules!
Live conductor Terminal L
Neutral conductor Terminal N
Protective conductor Earth terminal
Check secure fixation and proper function!
© 0001 20.07.2023 SLV GmbH, Daimlerstr. 21-23, 52531 Übach-Palenberg, Germany, Tel. +49 (0)2451 4833-0. Made in China.